Publicidad
Idiomas disponibles
Idiomas disponibles
FI - 30
− When the main switch is activated (1), Fig. 7, it lights up. The rinse water and then the
wash water begin to fill and heat up.
− The cycle can be adjusted to last up to a maximum of 4 minutes. Set the control (4) to the
time required, the pilot light will come on (3).
− When the pilot light (2) comes on, the machine is ready.
FI - 48 y FI - 48B
− Set the switch (1) (Fig. 8), to the 120" or 180" programme.
− The pilot light (2) will come on. The rinse and wash water will start to fill and heat up.
When the pilot light (3) comes on, the machine is ready. The cycle can be started by
pressing (4).
− The FI-48B automatically drains in each cycle. To completely empty the
remove the anti-overflow device (A) (fig. 12), set the switch (1) to the
and press the button (4) (Fig. 9).
− At the end of the day set the switch (1) to the 0 setting.
2.1.- Advice on how to wash correctly
− Put the amount of detergent indicated by the manufacturer into the tub.
− Control and maintain the level of rinse aid in the tank (D) (Fig. 10) and the pipe (T) with its
filter submerged.
Preparing the crockery
− Remove the biggest bits of food from the crockery before putting it into the baskets.
− Wash glassware first.
− Put the plates in the racks, but not on top of each other. (Fig. 11).
− Put cups and glasses in upside down.
− Put cutlery in the cutlery baskets with the handle at the bottom. Mix spoons with forks and
knives.
− Put the special cutlery holders in the base baskets or in the baskets with 16 spaces.
2.- USE
10
tub,
setting
Publicidad
