SUHNER ABRASIVE SMH 60-HTD Documentación Técnica página 12

1. N
1.1 g
enerAl notes on sAfety
This operation manual is applicable for the hand tool SMH
60-HTD.
The hand tool may only be handled by personnel
who are qualified.
It is imperative that you observe the safety instruc-
tions provided separately for the drive.
1.2 u
se of the mAchine for purposes for
which it is intended
This hand tool is only intended to be used with tools of
a maximum diameter of 45 mm for grinding, milling, pol-
ishing, deburring, engraving, satin finishing and brushing
processes.
1.3 i
ncorrect use
All uses other than those described under section
1.2 are regarded as incorrect use and are there-
fore not admissible.
1.4 d
eclArAtion of incorporAtion
The manufacturer Suhner Schweiz AG of Industriestrasse
10, CH-5242 Lupfig, hereby declares for the partly com-
pleted machinery (see reverse side for type and serial
no.) that the following fundamental requirements of the
Directive 2006/42/EC are applied and fulfilled in accord-
ance with Annex I: 1.1.2, 1.1.3, 1.1.5, 1.2.1, 1.2.2, 1.3.7,
1.3.8.1, 1.5.1, 1.5.4, and 1.6.1. Technical documenta-
tion was generated for the partly completed machinery
in accordance with Annex VII of the Machinery Direc-
tive. Document Agent: T. Fischer. Authorised sites are
provided with this technical documentation in paper or
electronic form on justified request. This partly complet-
ed machinery may be put into operation only when the
machine in which the partly completed machinery is to
be incorporated has been ascertained to fulfil the condi-
tions under the Machinery Directive. CH-Lupfig, 10/2019.
T. Fischer/Division manager
2. c
2.1 A
ssemBly instructions
read Sections 2 and 3 before activating the hand tool.
Only use hand pieces and grinding tools if they are in per-
fect condition. Only fit or set up hand tools and grinding
tools when the control unit is switched OFF. Observe the
standards and requirements which apply in your country.
12
S
oTES oN aFETy
ommISSIoNINg
It is imperative that you
2.1.1 c
onnecting the hAnd tool
Only utilize hand tools which have been approved
by SUHNER.
Plug the hand tool into/remove it from socket «A» or «B».
2.1.2 d /c
etAching onnecting the grinding tool
Lock the collet chuck shaft by inserting the locking clip.
Loosen the collet chuck with the collet chuck key. Remove
tool or clamping pin. To install, follow the above instruc-
tions in reverse order.
Never tighten chuck collets without a tool or
clamping pin. Only utilize tools which have been
approved by SUHNER.
The safety instructions issued by the tool manufacturer
must also be observed. Check that the diameter of the tool
is within the permitted limit and that the maximum permit-
ted speed is higher than the idle speed or set speed of the
machine. The tool shaft must fit the tool fitting exactly. The
tool needs to be clamped in the tool fitting once it is in as
deep as it can go. The bigger the open shaft length and
the smaller the clamping length, the lower the maximum
permitted speed, as follows: >20mm max. 50%, >25mm
max. 30%, >50mm max. 10% of the rotation speed. The
assembled tool must be able to turn freely. After this, a
trial run lasting a minimum of 30 seconds must be carried
out with no load. If tools vibrate, replace them instantly.