Bed Link Strap Kit (Optional) - Serta Motion Essentials II Manual Del Usuario

Menu
Table of Contents
STEP 1
Verify Bed Link Strap Kit contents: (2) bed link straps and (4)
slotted spacers (FIGURE 1).
FIGURE 1
(4) SLOTTED
SPACERS
STEP 2
Align both split bases side-by-side, leaving a gap of approximately
1"between the bases, at the center (FIGURE 2).
STEP 3
Plug the bases into an electrical power source. Using the remote
control, put the bases in the full "up" position (both head and foot).
STEP 4
At the head end of the base, loosen the (2) inside legs
approximately 1/4".
STEP 5
Slide (1) bed link strap between the base frame and loosened legs
(FIGURE 2). NOTE: Use the inside holes for Split Cal King and Split
Queen bases and the outside holes for King bases.
FIGURE 2
(1) BASE
FRAME

BED LINK STRAP KIT (optional)

(2) BED LINK
STRAPS
(1) BED STRAP
LINK
Serta Motion Essentials™ II Owners Manual 99301408-f
®
23