HIKOKI WR 18DH Instrucciones De Manejo página 13

(2) Avoid recharging at high temperatures. A rechargeable
battery will be hot immediately after use. If such a
battery is recharged immediately after use, its internal
chemical substance will deteriorate, and the battery life
will be shortened. Leave the battery and recharge it
after it has cooled for a while.
MOUNTING AND OPERATION
Action
Removing and inserting the battery
Charging
How to use the hook* 1
Mounting the socket* 2
Reversing the rotational direction*
Switch operation
How to use the LED light*
Tightening mode selector function*
Auto stop mode* 6
Auto slow mode* 7
Remaining battery indicator
Charging a USB device from a
electrical outlet (UC18YSL3)
Charging a USB device and battery
from a electrical outlet (UC18YSL3)
How to recharge USB device
(UC18YSL3)
When charging of USB device is
completed (UC18YSL3)
Selecting accessories
*1 How to use the hook
CAUTION
Install securely the hook. Unless the hook is securely
installed, it may cause an injury while using.
When electing to carry the tool hooked to your hip belt,
make sure to detach the tool socket. Failure to do so
may result in unexpected injury.
*2 Installing a socket
(1) Slide the O-ring out of the groove, then align the hole of
the socket with the hole of the anvil and insert the anvil
into the socket.
(2) Insert the pin into the socket.
(3) While making sure that the pin doesn't fall, attach the O-
ring to the groove on the socket.
*3 Reversing the rotational direction
NOTE
The push button can not be switched while the power
tool is turning. To switch the push button, stop the
power tool, then set the push button.
*4 How to use the LED light
To prevent the battery power consumption caused by
forgetting to turn off the LED light, the light goes off
automatically about 10 seconds after your finger is
released.
Figure Page
3
4
5
6
7
3
8
4 9
5 10
11
12
13
14-a
14-b
15
16
—
*5 Tightening mode selector function
CAUTION
Select tightening mode while the trigger switch is
released. Failure to do so could result in malfunction.
NOTE
○ The appropriate mode will vary depending on the screw
and the material being screwed. Adjust the tightening
mode setting by test-tightening a number of screws.
○ The tightening mode cannot be changed unless the
rechargeable battery has been mounted in the tool and
the switch has been pulled.
(1) High / Low mode selector switch (Fig. 10-a, Table 5)
2
The tightening mode switches between 4 different
rotation speeds each time the High / Low mode selector
2
switch is pressed.
3
Table 5: High / Low mode selector function setting
3
Indicator Maximum unloaded
3
lamps
3
1
4
4
4
2
4
5
3
5
5
4
5
(2) Auto stop mode selector switch (Fig. 10-b)
5
Each time the auto stop mode selector switch is
pressed, the auto stop function will switch between ON
and OFF.
253
*6 Auto stop mode (Table 6)
Stops automatically after a preset time has elapsed.
Push the Push button to the forward ("R") position, then
press the Auto stop mode selector switch to select the
setting.
13
Uses
speed
For work that
1200 min- requires fine
1
adjustments.
1800 min-
1
For work that
requires the power
to be suppressed.
2400 min- 1
2800 min- 1
For work that
(WR18DH)
requires power
3000 min- 1
and speed.
(WR36DH)
English