Maintenance
Maintenance Schedule
EVERY MONTH
Manually operate door. If it is unbalanced or binding, call a trained door systems technician.
l
Check to be sure door opens and closes fully. Adjust if necessary, see page 23.
l
Test the safety reversal system. Adjust if necessary, see page 24.
l
EVERY YEAR
Oil door rollers, bearings and hinges. The garage door opener does not require additional
l
lubrication. Do not grease the door tracks.
EVERY TWO TO THREE YEARS
Use a rag to wipe away the existing grease from the garage door opener rail. Reapply a small
l
layer of white lithium grease to the top and underside of the rail surface where the trolley
slides.
The Remote Control Battery
To prevent possible SERIOUS INJURY or DEATH:
NEVER allow small children near batteries.
l
If battery is swallowed, immediately notify doctor.
l
To reduce risk of fire, explosion or chemical burn:
Replace ONLY with 3V CR2032 coin batteries.
l
DO NOT recharge, disassemble, heat above 212°F (100°C) or incinerate.
l
To replace the battery, pry open the case in the middle,
then at each side with the visor clip. Insert replacement
battery positive side up (+). Replace the batteries with
only 3V CR2032 coin cell batteries. Dispose of old
batteries properly.
NOTICE: To complywith FCC and/or IndustryCanada (IC) rules, adjustment or modificationsof thistransceiver are prohibited. THERE
ARENO USER SERVICEABLEPARTS.
Thisdevice complieswith Part 15 of the FCC rulesand IC RSS-210. Operation issubject to the following two conditions: (1) thisdevice
maynot cause harmfulinterference, and (2) thisdevice must accept anyinterference received, including interference that maycause
undesired operation.
ThisClassBdigitalapparatuscomplieswith Canadian ICES-003.
31