VALERA HOTELLO 830 Serie Instrucciones De Uso página 2

All measures are in mm
190 mm
40 110 40
68
80
90
265 mm
100
150
75
35
95
Valera
20 VA MAX
IP24
Type 830. / xx xxx
- V~ 50-60Hz
### ###
- W
#### ####
Made in Switzerland
Valera
IP24
Type 830. /
xx xxx
### ### - V~ 50-60Hz
#### #### - W
Made in Switzerland
5
English
INSTRUCTIONS FOR USE AND
INSTALLATION
Read these instructions carefully before installation
and use.
Available also on www.valera.com
Hairdryer Type 830.01/.., 830.02/.., 830.03/..
R=with shaver socket
110-120V / 220-240V max 20VA
T=with 8 minute timer
L=with LED indicator
CAUTION
2
•Before use, the appliance must be
fitted and properly installed by a
qualified electrician.
•Important: In order to guarantee
additional protection,
recommended that a differential
breaker with an intervention current
not greater than 30 mA is installed in
the electrical system which feeds the
device. For further information,
contact a qualified electrician.
3 •This appliance can be used by
children from 8 years of age and
4
over, and by persons with limited
physical, sensory or mental abilities
or who lack the relevant experience
and knowledge, if they are suitably
supervised or have been educated to
use the appliance safely and made
aware of the associated risks.
•Do not allow children to play with the
appliance.
•Children must not perform cleaning
1
and maintenance procedures unless
6
supervised.
•If the supply cord is damaged, it
must be
manufacturer, its service agent or a
similarly qualified person in order to
avoid a hazard. Do not use your unit
if it is not working properly. Do not
try to repair this electrical unit
yourself, rather
authorized technician.
• Only connect the appliance to an alternate current power
supply, and make sure that the mains voltage corresponds
to the one indicated on the appliance.
• This hairdryer must be installed out of reach of
persons using the bath or shower. Always comply
with the requirements of current electrical system
regulations. Do not use this appliance near
bathtubs, showers, basins or other vessels
containing water.
• Make sure that the air inlet grills at the bottom of the
appliance are never obstructed.
• Do not use the appliance if any malfunction is noted or if
the power cable is damaged in any way.
• The elements used to pack the appliance (plastic bags,
cardboard box, etc...) must not be left within reach of
small children, as they are a potential source of danger.
• This appliance must only be used for the purposes for
which it has been specifically designed: to dry hair (for
models 830.01/R, 830.02/R, 830.03/R also to operate and
recharge electric razors, max 20VA). Any other use is to
be considered improper and therefore dangerous. The
manufacturer will not be considered liable for any damage
it is
deriving from improper or incorrect use of the appliance.
IMPORTANT
This appliance complies with safety requirements for
electrical equipment.
This hairdryer is fitted with a safety thermostat. It will stop
automatically if it overheats. After a short time it will start
up again.
Before use, make sure that the appliance air inlet grills are
perfectly clean.
The manufacturer will not be considered liable for any
damage to persons or property deriving from failure to
comply with the above recommendations, or improper use of
the hairdryer.
This appliance conforms to
2004/108/EC, 2009/125/EC, 2006/95/EC and Regulation
(EC) No. 1275/2008.
INSTRUCTIONS FOR USE
To turn the unit on, place the mains switch to position "I".
Fig. 6 (Only for models 830.01/RTL, 830.02/RTL, 830.03/RTL).
To start the hairdryer, remove the handpiece from its housing.
Models 830.01/R, 830.02/R, 830.03/R are fitted with 110-
120V and 220-240V, 50/60 Hz~ shaver sockets.
These sockets, which can be accessed by lifting a special
protection flap (fig. 5), must only be used to run or recharge
electric shavers (max 20VA).
IMPORTANT: never connect other appliances such as electric
coffee machines, heaters, etc. to these sockets. Models
830.01/T, 830.02/T and 830.03/T are fitted with an electric
timer which turns the appliance off automatically after a pre-
set time (8 min.). To turn it back on again, simply replace the
replaced by the
handpiece in its housing and then remove it again.
When not in use, the mains switch on the wall holder should
be in the "0" position. (only for the models equipped with
mains switch).
CLEANING AND MAINTENANCE
Plastic components must be cleaned using a cloth damped
contact an
in warm water.
WARNING: do not use abrasive products or chemical
detergents.
4
Mod. Nr.
Date of purchase
Kaufdatum
Date d'achat
Data d'acquisto
Fecha de adquisición
Datum aankoop
Name and full address of purchaser
Name und vollständige Anschrift des Käufers
Nom et adresse completè de l'acheteur
Nome e indirizzo completo dell'acquirente
Nombre y dirección completa del comprador
Naam en adres van de consument
Nome e endereço do cliente
Kjøperens fullstendige navn og adresse
European Directives
Köparens namn och fullständig adress
Ostajan nimi ja täydellinen osoite
Køberens fulde navn og adresse
Vevő neve éstelies cime
Jméno a adresa záhaznika
Numele i adresa completa ˘ a compãrãtoruluii
Nazwisko oraz pelny adres kupującego
Alıcının tam ismi ve adresi
Meno a celá adresa kupujúceho/zákazníka
Ligo Electric SA - 6853 Ligornetto / Mendrisio - Switzerland
Data de compra Datum prodeje Dátum nákupu
Innkjøpsdato Data cumpãrãrii
Inköpsdatum Data zakupu
Ostopäivämäärä
Købsdato
Eladás dátuma Satın alma tarihi