Publicidad
Idiomas disponibles
Idiomas disponibles
Operation
Using the Door Control
SYNCHRONIZE THE DOOR CONTROL
To synchronize the door control to the garage door opener, press the push bar until the garage door opener activates (it may take up to 3
presses). Test the door control by pressing the push bar, each press of the push bar will activate the garage door opener.
10 Minute TTC LED
FEATURE
PUSH BAR
LOCK
Designed to prevent operation of the door from hand-held remote
controls. However, the door will open and close from the Door
Control, keypad, and myQ
MOTION SENSOR
This feature will automatically turn on the garage door opener
lights when motion is sensed. The lights will come on for 4-1/2
minutes, then shut off.
TIMER-TO-CLOSE (TTC)
The TTC feature automatically closes the door after a specified
time period (1, 5, or 10 minutes). Once the TTC has been set and
the door is open, the LED for the selected close interval will blink
and begin to count down to close the door. The control panel will
beep and the garage door opener lights will flash before closing
the door.
The TTC feature will deactivate if the garage door encounters an
obstruction twice; or the safety reversing sensors are incorrectly
installed. The garage door will reverse open and WILL NOT close
until the obstructions are clear or the safety reversing sensors are
correctly installed. When the obstruction has been cleared or the
safety reversing sensors have been aligned, the door will close
when the garage door opener is activated.
NOTE: The light must be programmed to the operator for the Timer
To Close or myQ
App to be able to close the door unattended.
®
Push Bar
1 Minute TTC LED
5 Minute TTC LED
App.
®
HOLD OPEN Button for the Timer-
To-Close (TTC)
LIGHT Button
Motion Sensor
HOW
TO:
Press the push bar to open/close the door.
Activate: Press and hold the LOCK button for 2 seconds. The
command LED will flash as long as the lock feature is activated
and your handheld remote control will not operate your door
at this time.
Deactivate: Press and hold the LOCK button again for 2
seconds. The command LED will stop flashing and normal
operation will resume.
Activate/Deactivate:
Slide the motion sensor switch ON or OFF.
Activate: Press and hold the ON button until one of the TTC
LEDs light up. Then press the ON button again to cycle through
the time interval options (the corresponding TTC LED will light
for each time interval). The garage door opener light bulbs will
blink as confirmation.
Deactivate: Press and hold the OFF button until all TTC LEDs
turn off and a beep is heard from the control panel.
To suspend the TTC: To suspend the TTC and temporarily hold
the door open, press and release the HOLD OPEN button (the
HOLD OPEN LED will turn solid). The TTC will remain suspended
until the HOLD OPEN button is pressed again or the garage door
opener is activated from another device (door control, remote
control, keypad, etc.).
14
Publicidad
