Publicidad
Idiomas disponibles
Idiomas disponibles
Programming
Program the Smart LED Light
Your garage door opener remote light has already been
programmed at the factory to operate with your opener.
Any additional or replacement remote lights will need to be
programmed.
PROGRAM A DOOR OPENER TO THE SMART LED LIGHT
1.
Press the LEARN button on the light until the green LED
comes ON.
2.
Press the LEARN button on the door opener. OR
On the Smart Control Panel
myQ Accessory.
3.
The code has been programmed when the remote light blinks
once.
ADD THE SMART LED LIGHT TO myQ ACCOUNT
1.
Press the LEARN button on the light until the green LED
comes ON.
2.
Login to the myQ app and add the Smart LED Light.
TO ERASE ALL PROGRAMMING FROM THE SMART LED
LIGHT
1.
Press and hold the LEARN button until the LED turns off
(6-10 seconds). All programming is now erased.
To Erase the Memory
ERASE ALL REMOTE CONTROLS AND KEYLESS ENTRIES
1.
Press and hold the LEARN button on garage door opener
until the learn LED goes out (approximately 6 seconds). All
remote control and keyless entry codes are now erased.
Reprogram any accessory you wish to use.
ERASE ALL DEVICES (Including myQ enabled
accessories)
1.
Press and hold the LEARN button on garage door opener
until the learn LED goes out (approximately 6 seconds).
2.
Immediately press and hold the LEARN button again until the
learn LED goes out. All codes are now erased. Reprogram
any accessory you wish to use.
ERASE THE WI-FI NETWORK FROM THE GARAGE DOOR
OPENER
1.
Press and hold the black adjustment button on the garage
door opener until 3 beeps are heard (Approximately 6
seconds).
ERASE A myQ ACCOUNT
Go to support.chamberlaingroup.com to delete your myQ account.
go to Menu > Program >
®
Door Opener
LEARN Button
Motion-Detecting
Control Panel
Black Adjustment Button
LEARN
Button
17
LEARN Button
Publicidad
