Publicidad
Idiomas disponibles
Idiomas disponibles
ADJUSTABLE PLASTIC FEET
DOOR RACK
OPERATION
BEFORE USE
This refrigerating appliance is not intended to be used as a built-in appliance.
Remove all of the packaging, including the foam backing at the bottom of the unit and the tape that
fixes the shelves and door bins inside.
Place the refrigerator to a proper position, and adjust the feet to level. It is recommended to wipe
out your unit with a warm soapy cloth and dry it thoroughly before use.
Place the refrigerator and adjust to level, clean it, let the refrigerator stand for above 4-6 hours, and
then power the unit on. This helps make sure that the oil from the compressor has settled properly,
and will help your unit run normally.
STARTING
Connect the power cord, and turn on the power switch.
Upon startup for the first time, the screen will display respective set temperature values (the
temperature of the fridge section is set to 5°C, the temperature of the freezer is set to-18°C).
The default mode is energy saving upon startup: The screen displays for 20s and then goes off. This
mode to save energy and prolong the service life of LED lights.
When the refrigerator stays in the packing box, plastic feet are in tightened
state. After carrying it out from the packing box for placement, please make
sure to adjust two front plastic feet until the height is suitable; just adjust two
plastic feet with a wrench or directly by hand.
Plastic feet and rear rollers must touch the ground to prevent the refrigerator
from movement, vibration or noise. When moving the refrigerator, adjust
plastic feet counter clockwise to keep them off the ground, and then push the
refrigerator gently to move it.
Disassembly: Hold both sides of the door rack with both hands. Push it from the
side without the guide and push it inward as seen in the diagram. Push until the
edge of the door rack is separated from the grove of the liner.
Installation: Hold both sides of the door rack with both hands. Install the buckle
of the guide side at first. Then push the other side inward slightly, the guide will
then click into place and the door rack will be installed. Please make sure it is
installed properly before use.
51
Publicidad
