Publicidad
Idiomas disponibles
Idiomas disponibles
˜ Changing/inserting the nozzle
I
[
]
[
]
1 ]
[
[
2 ]
[
3 ]
Hold the product with the nozzle head
facing upwards before unscrewing the union
nut
. This prevents parts from falling out.
[
]
Turn the union nut
[
direction.
Remove the union nut
nozzle head
from the spray unit
[
]
If a nozzle
is already mounted:
1 ]
[
–
Remove the nozzle from the needle
–
If necessary, lever the nozzle out carefully
with a screwdriver.
Place the desired nozzle
Place the nozzle head
Place the union nut
Tightening: Turn the union nut
clockwise direction.
[
]
in a counter-clockwise
]
together with the
[
]
.
[
4 ]
.
[
2 ]
on the needle
1 ]
[
on the nozzle
[
]
1 ]
[
on the small thread
[
]
in a
[
]
Choosing the correct nozzle
Nozzle*
[
1 ]
White
1.5 mm Low viscosity
Black
1.8 mm Water-based paints
Red
2.2 mm High viscosity
Cyan
2.6 mm Oil-based paints
* The diameter of the nozzle-opening is
imprinted on the inside of the nozzle
More information:
see "Checking viscosity"
˜ Filling in spray material
Fig. G
Unscrew the paint container
unit
.
4 ]
[
Insert the riser tube
thread
.
[
]
NOTE
For working on a low-placed spraying area:
u
Attach the riser tube
forward:
Towards the nozzle head
For working on a higher placed spraying
u
area: Attach the riser tube
.
2 ]
[
points backwards:
.
Towards the motor unit
.
3 ]
[
Fill the spray material into the paint
container
9 ]
[
Screw the paint container
unit
.
[
4 ]
Application
from the spray
[
9 ]
into the large
[
]
so that it points
[
]
[
]
so that it
[
]
[
]
.
to the spray
[
9 ]
GB/MT
.
1 ]
[
63
Publicidad
