Publicidad
Idiomas disponibles
Idiomas disponibles
For the snap-on type bent pipe assembly
To attach, insert the hose end into the bent pipe assem-
bly. Make sure that the tabs on the hose end snap into
the holes on the bent pipe assembly.
To remove, pull the bent pipe assembly while pressing
both of the tabs on the hose end.
1
2
Fig.16
► 1. Hose end 2. Tab 3. Hole 4. Bent pipe assembly
Assembling nozzle and wand
Optional accessory
NOTE: The type of the nozzle and wand included in
the product varies depending on countries. In some
countries, the nozzle and wand are not included.
1.
Twist and insert the nozzle to the extension wand.
2
Fig.17
► 1. Extension wand 2. Flexible rubber nozzle
3. Corner nozzle 4. Floor/carpet switching t-nozzle
3
1
3
4
When using floor/carpet switching t-nozzle, you can
change the mode depending on the place.
—
Floor mode: suitable for a smooth place such as a
hard floor
—
Carpet mode: suitable for a shaggy place such as
a carpet or a rug
4
1
Fig.18
► 1. Mode switching button 2. Floor mode 3. Carpet mode
NOTE: By twisting the nozzle while inserting, the noz-
zle can be attached to the extension wand securely.
NOTE: For the model with ø38 mm hose and front
cuff 38, attach the supplied nozzle to the aluminum
bent pipe / aluminum straight pipe.
2.
Follow the procedures below, depending on the
type of the extension wand:
NOTE: The slide-type extension wand and the ring-
type extension wand are not compatible with each
other. If you want to change the slide-type extension
wand to the ring-type extension wand or vice versa,
change the bent pipe assembly also.
For the slide-type extension wand
Shoulder the vacuum cleaner body then insert the
extension wand into the bent pipe assembly until it
clicks. To disconnect, extract the extension wand with
pressing the button.
Fig.19
► 1. Bent pipe assembly 2. Button 3. Slide-type exten-
sion wand 4. Flexible rubber nozzle
11 ENGLISH
2
3
1
1
3
2
4
Publicidad
