Publicidad
Idiomas disponibles
Idiomas disponibles
IIARE AND
CLEANING
Control
Panel
- clean with a soft, damp cloth. Do not use
abrasive substances.Do not spray cleaners directly on the panel.
Tumbler
- remove
any stains such as crayon, ink pen or fabric
dye (from
new items such as towels
or leans)
with
an all-purpose
cleaner.
Then
tumble
old towels
or rags to remove
any excess
stain or cleaning
substance.
Once
these
steps are
done,
stains
may still be visible,
but should not transfer
to subsequent
loads.
Cabinet
- wipe
off any marks
with
soap and water.
Dryer
Exhaust
System
- should
be inspected
and cleaned
once
a year
to
maintain
optimum
performance.
The
outside
exhaust
hood
should
be cleaned
more
frequently
to
ensure
proper
operation.
(Refer
to the Installation
Instructions
for more
information.)
REPLACE DRUM
LIGHT
Instructions
for replacing
the bulb:
I)
Unplug or disconnect
the dryer from the electrical
power
supply,
2)
Open the door and use a Phillips screwdriver
to remove the
screw attaching the lens to the tumbler front.
3)
Remove lens cover by pulling cover toward
center of tum-
bler.
4)
Rotate bulb counter-clockwise
to remove from socket.
5)
Replace the bulb with a 120 volt, 10 watt maximum cande-
labra base light bulb.
6)
Turn the light bulb clockwise into socket.
7)
Replace lens cover by hooking plastic tabs into tumbler front
below the light housing.
8)
Reinstall the screw into the lens cover screw hole.
9)
Reconnect dryer to power supply.
!: EVERSE THE
DOOR
Instructions
for reversing
the dryer
door:
I)
Remove the hinge hole covers and screws.
2)
While supporting
the door, remove 2 screws in the hinges that secure the hinges to the cabinet.
3)
Remove door by lifting slightly at the hinges and pulling the hinge tabs out of the hinge slots.
4)
Move the following
parts to the opposite side of the door: 2 hinges and 4 hinge screws, 4 door screws,
door strike and screw, inner door cover plate and screw.
5)
Attach the door to the opposite
side of the cabinet using the 2 counter sunk hinge screws. (See below).
Screw the lower hinge screw in first.This
will help to align the door and hinges.
6)
Replace the hinge hole covers to the opposite side.
Door
Catch
_
Counter
Sunk
Screw
Door
Door
/
Strike
Door
_Screws
8
Publicidad
