Eurocave VOV3 Modo De Empleo página 27

IV. Using the appliance for the first time
For the VoV3 electronic model only: turn the door opening key to switch the appliance to
manual mode (the EuroCave logo will then slowly flash)
Before using the appliance for the first time, rinse out the circuit with a bottle of warm water, following the steps below:
ˆ Take the rigid discharge pipe and adjust its length to the height of the bottle. The pipe must reach the bottom of the
bottle. (A)
ˆ Insert the rigid discharge pipe into the bottle
ˆ Lift the bottle until it reaches the bottle sealer. (B)
ˆ Press the springs to position the bottle on the shelf. (C)
ˆ Place a carafe under the tap and press its lever to activate it.
ˆ Once the bottle is empty, drain the pipes
of any remaining water by continuously
pressing the dispenser lever.
ˆ Repeat the process for each bottle circuit
ˆ After setting up each bottle, press the
dispenser lever to release the nitrogen and
expel air from the bottle neck.
V. Installing and setting up wine bottles
ˆ Take the rigid discharge pipe and adjust its length to the height of the bottle
ˆ Open the wine bottle
ˆ Insert the pipe into the bottle by pressing the spring upwards and secure the bottle by placing it on the shelf in
the selected compartment, vertical to the ball joint fitted to the wine suction system
ˆ Make sure that none of the tubes has kinks
ˆ Repeat the process for each bottle
ˆ After setting up each bottle, press the dispenser lever (VOV3 manual) or one of the control buttons (VOV3
electronic).
VI. Changing wine bottles
ˆ When a bottle is empty, remove it by tilting it slightly and pulling it outwards
ˆ Drain the rigid discharge pipe
ˆ If you replace it with the same type of wine, proceed as described in the paragraph (see 5-V)
ˆ If you are changing the type of wine, clean the circuit and rigid discharge pipe using a bottle of warm water (see
5-IV).
VII. Using Magnum bottles (only for the VOV3 manual)
Your Vin au Verre was designed to hold all types of bottles. Its clever ball joint system on springs allows you to easily install
Magnums or any other bottles. To do so, move the ball joint fitted to the wine suction system by gently removing it from its
mounting. Next, position it on the rear mounting. Adjust the length of the transparent tube to the height of the bottle. The
tube must reach the bottom of the bottle. Up to 3 Magnum bottles can be stored together in each compartment.
N.B.: If you have not used your appliance for a long time, remove the bottles of wine, rinse and dry
the wine outflow pipes, close the valve of the nitrogen bottle, expel the remaining nitrogen and lock
the taps in the open position (with the securing rings).
(A) (B) (C)
GB
-7-