Eurocave VOV3 Modo De Empleo página 28

6- TEMPERATURE SETTING
The appliance has 2 temperature controls on the front allowing you to independently set the temperature of each compartment.
Each control is located beneath the compartment that it controls.
You can set the temperatures to bring to the correct serving temperature:
ˆ  FSXXPIW SJ [LMXI [MRIW   FSXXPIW SJ VIH [MRIW
ˆ FSXXPIW SJ VIH [MRIW
ˆ FSXXPIW SJ [LMXI [MRIW
In operation, the value shown on the displays, when the keys are not being pressed, is always the temperature inside the
compartment.
The desired temperature for each compartment is set as follows:
1. Press the
appear, press again
with a flashing dot (default temperature setting).
2. 2. You can then change the setting by pressing the
and
3. Once you have finished setting the temperature, confirm
the new value by pressing the
appear again.
4. After a few seconds, the display automatically returns to
the temperature inside the compartment.
The room in which the Vin au Verre is installed must have an ambient temperature
of 6° - 30°C for the appliance to function correctly. Outside of this temperature range
operating temperatures are not guaranteed.
Your appliance is fitted with a heater allowing the Vin au Verre to be used in a location with an
ambient temperature of 6°C - 30°C.
The heater is located in the appliance's right-hand compartment.
If you want to bring your wines to a serving temperature above the ambient temperature, it is
absolutely vital that you place the bottles in the right-hand compartment. The temperature of
the left-hand compartment cannot be higher than the ambient temperature.
-8-
VOV3 Manual
key for 2 seconds, the letters "SET" will
tand the setting is then displayed
keys (flashing dot displayed).
, the letters SET will
VOV3 Electronic
1. Press the key, the letters "SETI" will flash then
the set temperature will appear.
2. 2. You can then change the setting by pressing the
and keys.
3. 3. Once you have finished setting the temperature,
confirm the new value by pressing the P key, the new setting
is registered and the display returns to the temperature
inside the compartment.