Kärcher BD 50/50 C Bp Pad Wet Manual Del Usuario página 9

Drain off clean water
 Unscrew the lock of the fresh water
reservoir.
Transport
DANGER
Risk of injury! When loading or unload-
ing the machine, it may only be operat-
ed on gradients up to the maximum
value (see "Technical Specifications").
Drive slowly.
CAUTION
Risk of personal injury or damage!
Mind the weight of the appliance during
transport.
 Lift the pedal for the transport chas-
sis.
 Use the pushing handle to push the
appliance.
 When transporting in vehicles, se-
cure the appliance according to the
guidelines from slipping and tipping
over.
Storage
CAUTION
Risk of personal injury or damage!
Consider the weight of the appliance
when storing it.
This appliance must only be stored in
interior rooms.
Care and maintenance
DANGER
Risk of injury! Set the programme se-
lector switch to "OFF" and pull the
mains plug of the charger prior to per-
forming any work on the appliance.
 Drain and dispose of the dirt water
and the residual fresh water.
Maintenance schedule
After each operation
ATTENTION
Risk of damage. Do not sluice the ap-
pliance with water and do not use ag-
gressive detergents.
 Drain off dirt water.
 Rinse the waste water tank with
clear water.
 Clean the outside of the appliance
with a damp cloth which has been
soaked in mild detergent.
 Check the fluff filter, clean if re-
quired.
 Clean the vacuum lips and the wip-
ing lips, check for wear and replace
if required.
 Check the brush for wear and re-
place if required (see "Maintenance
tasks").
 Charge the battery:
If the charging state of the battery is
under 50%, charge the battery fully
and without interruption.
If the charging state of the battery is
over 50%, only recharge the battery
if the entire operation duration will
be required when next used.
Weekly
 When used regularly, charge the
battery fully and without interruption
at least once a week.
Monthly
 Check battery poles for oxidation,
brush off if necessary. Ensure that
the connection cable sits firmly.
 Clean the seals between waste wa-
ter tank and cover and check for
tightness, replace if required.
 Clean sieve.
 Check the acid density of the cells if
the batteries are not maintenance-
free batteries.
 For long periods of disuse, only turn
the device off when the battery is
fully charged. Fully recharge the
battery at least every month.
Yearly
 Have the prescribed inspection car-
ried out by the customer service.
7
-
EN
Maintenance Works
Cleaning the sieve
1
2
1 Cover
2 Cover
 Open the cover.
 Turn cover the clockwise and re-
move it.
 Remove and clean the sieve lying
beneath it.
 Insert the sieve.
 Replace the cover and lock it by
turning it anti-clockwise.
 Close cover.
Replace or turn vacuum lips
1 Wear indicator
2 Vacuum lip
The vacuum lips must be replaced or
reversed if they are worn down to the
wear indicator.
 Remove the vacuum bar.
 Unscrew the star grips.
 Remove the plastic parts.
 Remove the vacuum lips.
 Insert new or reversed vacuum lips.
 Insert the plastic parts.
 Screw in and tighten the star grips.
9