Cleaning And Maintenance; Routine Maintenance; Special Maintenance - Bartscher 132.115 Manual De Instrucciones Para El Uso Y El Mantenimiento

the heating elements come on again automatically.
Do not touch the plate with the hands when hot.
- Turn the knob (Fig. 3) back to position "0".
- If the appliance is not used, switch off the circuit breaker.
3.

3.1 ROUTINE MAINTENANCE

At the end of the working day, clean the appliance, both for reasons of hygiene and to prevent operating faults.
Do not clean the appliance with direct or high-pressure jets of water and do not use metal pads, brushes or scra-
pers in normal steel. If necessary, use stainless steel pads, but do not rub them against the grain of the metal
of the appliance. Use warm soapy water on steel surfaces and then rinse in plenty of water and dry with a soft
cloth. Maintain the shine by regular polishing with a normal liquid polish. Do not wash the work top or floor with
hydrochloric acid.
PLATE
In order to remove any encrusted residue, scrape with a hard plastic spatula positioned at an angle. Clean the
plate regularly using a damp cloth. After cleaning, switch the plate on for a few minutes at the maximun setting in
order to dry it as quickly as possible. Allow the plate to cool and apply a thin layer of vaseline oil.

3.2 SPECIAL MAINTENANCE

At regular intervals (at least once a year or more often in cases of frequent use), service the appliance thoroughly.
Contact a specialised and experienced technician. A maintenance contract should be taken out with a centre
approved by the company.
THE MANUFACTURER ACCEPTS NO RESPONSIBILITY FOR HARM CAUSED BY INCORRECT INTERVEN-
TIONS, TAMPERING WITH THE APPLIANCE, MISUSE, POOR MAINTENANCE, NON-COMPLIANCE WITH
CURRENT REGULATIONS AND INEXPERT USE.
THE MANUFACTURER RESERVES THE RIGHT TO WITHOUT NOTICE MODIFY THE FEATURES OF THE
APPLIANCES DESCRIBED IN THIS MANUAL.
SWITCH-OFF

CLEANING AND MAINTENANCE

Pag. 7