Cleaning - Bartscher 162913 Manual De Uso Y Mantenimento

NOTE!
Remove used frying oil/fat with care for environment and according to the
valid regulations.
Overheating protection mechanism

In case of accidental engaging of the deep fat fryer without frying oil in the basin or
without sufficient amount of frying oil in the basin, the device automatically shuts
down after reaching the temperature of ca. 230 °C. Whenever this occurs, switch the
device off using the ON/OFF switch and leave it to cool off.
After the device has automatically turned off via
the overheating prevention system, it can only be
reactivated by pressing the RESET button at the
back of the control panel.

For this purpose, wait until the device cools off, then
unscrew the plastic plug of the RESET button counter-
clockwise, press the peg and again screw the plug
turning it clockwise.
The device may be switched on now.

6. Cleaning

WARNING!
Before cleaning set the temperature controller to "0",turn
the device off with use of ON/OFF switch and disconnect
it from the power supply (pull the plug!). Let the device to
cool down.
Do not use any kind of pressure water jet for cleaning the device.
Protect the device from the water penetration.
CAUTION!
Never use sharp or scouring cleaning agents which may scratch
the surface of the device.
Never use any cleaning agents containing gasoline or solvents.
RESET button
- 41 -