Publicidad
Idiomas disponibles
Idiomas disponibles
ASSEMBLY
WARNING:
To avoid serious personal injury, always make
sure the table saw is securely mounted to a
workbench or an approved leg stand. NEVER
operate the saw on the floor.
MOUNTING HOLES
The table saw must be mounted to a firm supporting surface
such as a workbench or leg stand that positions the saw
table at waist height. Four bolt holes have been provided in
the saw's base for this purpose. Each of the four mounting
holes should be bolted securely using 1/4 in. machine bolts,
lock washers, and hex nuts (not included). Bolts should be of
sufficient length to accommodate the saw base, lock wash-
ers, hex nuts, and the thickness of the workbench. Tighten
all four bolts securely.
Carefully check the workbench after mounting to make sure
that no movement can occur during use. If any tipping, slid-
ing, or walking is noted, secure the workbench to the floor
before operating.
TO STORE THE TABLE SAW ACCESSORIES
See Figures 6 - 7.
The table saw has two convenient storage areas (one on
either side of the saw cabinet) specifically designed for the
saw's accessories.
BLADE
WRENCHES
PUSH STICK
15 − English
Fig. 6
MITER
GAUGE
Fig. 7
Publicidad
