Descargar Imprimir esta página

RIDGID R45171NS Manual Del Operador página 36

Publicidad

Idiomas disponibles

Idiomas disponibles

ADJUSTMENTS
 Adjust the 0° stop screw until it rests against the stop pin.
 Adjust the plus and minus 45° stop screws using a 45°
triangle and the steps above.
TO CHECK THE ALIGNMENT OF THE RIP
FENCE TO THE BLADE
See Figure 48.
The rip fence must be parallel to the saw blade and the miter
gauge grooves.
WARNING:
A misaligned rip fence can cause kickbacks and
jams. To reduce the risk of injury, always maintain
proper rip fence alignment.
 Unplug the saw.
 Remove the blade guard, riving knife, and anti-kickback
pawls. Raise the blade by turning the height/bevel adjust-
ing handwheel.
 Verify the blade is parallel to the miter gauge groove as
described in the Adjusting the Blade Parallel to the Miter
Gauge Groove (Removing Heel) section in Operations.
 Move the rip fence near the saw blade (about three inches
away) and lock the rip fence in place with the locking
lever.
 Mark beside one of the blade teeth at the front of the
blade. Using a ruler, measure the distance from the inside
face of the blade tooth to the to the inside face of the rip
fence.
NOTE: For greater accuracy, place the marked blade
tooth on top of the ruler.
 Turn the blade so the marked tooth is at the back.
 Move the ruler to the rear and again measure the distance
from the inside face of the blade tooth to the inside face
of the rip fence. If the distances are the same, the blade
and the rip fence are parallel.
If the distances are different:
 Loosen the two screws located on top of the rip fence.
 Adjust the rip fence.
 Alternately retighten the screws. Recheck alignment.
 Repeat steps as needed until rip fence is correctly aligned.
 Replace blade guard, riving knife, and anti-kickback pawls.
TO CHECK THE TIGHTNESS OF THE RIP
FENCE LOCKING LEVER
See Figures 48 - 49.
The locking lever on the rip fence should hold the rip fence
securely against the front and back rails. The lever should
not be difficult to push down and lock. To assure proper
fence lock adjustment:
SCREWS
LOCK NUT
 Lock the rip fence in place.
 Try moving the fence from side-to-side. If the fence moves,
tighten the lock nut 1/4 turn.
 With the rip fence in the locked position, recheck rip
fence parallelism with the miter gauge groove and adjust
if necessary.
36 − English
BLADE
RIP
TOOTH
FENCE
LOCKING
LEVER
RULER
Fig. 48
Fig. 49

Publicidad

loading