Publicidad
Idiomas disponibles
Idiomas disponibles
1. SAFETY SUMMARY
DANGER:
DO NOT pour water into the remote control switch (hereafter called
"controller").
This product is equipped with electrical parts.
If poured, it will cause a serious electrical shock.
WARNING:
DO NOT perform installation work and electrical wiring connection
by yourself. Contact your distributor or dealer of HITACHI and ask
them for installation work and electrical wiring by service person.
CAUTION:
DO NOT install the indoor unit, outdoor unit, controller and cable at
such places as;
Where there is oil vapor and the oil is dispersed.
Where the hot springs are near (in a sulfuric environment).
Where generation, fl owing, staying or leaking of fl ammable
gas is detected.
Where the sea is near (in the salty environment).
An acid or alkaline environment.
2. INSTALLATION WORK
2.1. SELECTION OF INSTALLATION PLACE
Select a suitable place for handling and determine the installation place
of the controller with the customer's acceptance.
Do not install the controller at such places as:
Where children can touch.
Where the air from the air conditioner is directly discharged.
Especially in case that a Remote Controller thermostat is used, select
the installation place in consideration with the following points:
Where the average room temperature is detectable.
Where the thermostat is not exposed directy to the sun.
Where there is no source of heat.
Where the thermostat is not affected with the outdoor air by opening
and closing doors.
2.2. BEFORE INSTALLATION
Check the contents and the number of the accessories in the packing.
2 screws M4x16L
Remote control
for fi xing the
switch for
holding bracket
operation control
onto the wall
INSTALLATION MANUAL
1 Band for fi xing
1 Ring core
cable to ring core
CAUTION:
DO NOT install the indoor unit, outdoor unit, controller and cable
within approximately 3 meters from strong electro magnetic wave
radiators such as medical equipment. In case that the controller is
installed in a place where there is electromagnetic wave radiation,
shield the controller and cables by covering with the steel box and
running the cable through the metal conduit tube.
In case that there is electric noise at the power source for the
indoor unit, provide a noise fi lter.
NOTE:
This manual MUST be handed over to those who undertake the
following work. Customers are requested to keep it for future
reference.
(Installation) --> (Wiring) --> (Test Run) --> (Customer)
2.3. INSTALLATION SPACE
In case of installing the
controllers in vertical line,
keep a distance more than
50mm between the controllers
vertically.
If the distance is insuffi cient,
the controller can not be
taken out.
7
> 50mm
Publicidad
