HIKOKI H 3641 DA Instrucciones De Manejo página 10

English
USB DEVICE CONNECTION
PRECAUTIONS (UC18YSL3)
When an unexpected problem occurs, the data in a USB
device connected to this product may be corrupted or lost.
Always make sure to back up any data contained in the
USB device prior to use with this product.
Please be aware that our company accepts absolutely no
responsibility for any data stored in a USB device that is
corrupted or lost, nor for any damage that may occur to a
connected device.
WARNING
○ Prior to use, check the connecting USB cable for any
defect or damage.
Using a defective or damaged USB cable can cause
smoke emission or ignition.
○ When the product is not being used, cover the USB port
with the rubber cover.
Buildup of dust etc. in the USB port can cause smoke
emission or ignition.
NOTE
○ There may be an occasional pause during USB
recharging.
○ When a USB device is not being charged, remove the
USB device from the charger.
Failure to do so may not only reduce the battery life of a
USB device, but may also result in unexpected
accidents.
○ It may not be possible to charge some USB devices,
depending on the type of device.
NAMES OF PARTS
The numbers in the list below correspond to Fig. 1–Fig. 20.
1 Tool
2 Front cap
3 Grip
4 Grip (B)
5 On-lock Switch
6 Trigger switch
7 Handle
8 Impact rate selector switch
9 Display lamp
10 Name plate
11 Battery
12 Side handle
13 Motor
14 Tail cover
15 LED light
16 Housing
17 Cylinder Case Cover
18 Latch
19 Charge indicator lamp
20 Remaining battery indicator switch
21 Remaining battery indicator lamp
22 Display panel
23 Grease
24 Grip
25 Handle holder
26 Bolt
27 Handle holder attachment area
28 Sliding grooves (Product)
29 Terminal (Product)
30 Air gun
31 Terminal (Battery)
32 Sliding grooves (Battery)
33 Rubber cover
34 USB port
35 USB cable
SYMBOLS
WARNING
The following show symbols used for the machine.
Be sure that you understand their meaning before
use.
H3641DA: Cordless Demolition Hammer
Low Vibration Handle
To reduce the risk of injury, user must read
instruction manual.
Only for EU countries
Do not dispose of electric tools together with
household waste material!
In observance of European Directive
2012/19/EU on waste electrical and electronic
equipment and its implementation in
accordance with national law, electric tools that
have reached the end of their life must be
collected separately and returned to an
environmentally compatible recycling facility.
Direct current
V
Rated voltage
Bpm Full-load impact rate
Weight * 1
kg
(According to EPTA-Procedure 01/2014)
Switching ON
0
Switching OFF
Impact rate selector switch
10