HIKOKI H 3641 DA Instrucciones De Manejo página 15

Symptom
Tool doesn't run
Tool suddenly stopped
Tool bits
-can't be attached
-fall off
Concrete can't be smoothly
demolished.
Battery cannot be installed.
Possible cause
Concrete dust has accumulated on
the terminals of the battery
installation compartment as well as
on the battery sliding grooves.
Tool was overburdened
Battery or tool is overheated.
The shape of the attachment portion
doesn't match
The bit is worn
Attempting to install a battery other
than that specified for the tool.
15
Remedy
Clean off the accumulated concrete
dust with an air gun or a dry cloth.
Remove the cause of the
overburdening.
Allow the tool and battery to
thoroughly cool.
For the SDS-max shank type, use a
bit with a diameter that is within the
designated range.
Sharpen or replace with a new bit.
Please install a multi volt type battery.
English