Descargar Imprimir esta página

Hotpoint Ariston UT 104S P 0 /HA Manual De Instrucciones página 28

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

When the set time has elapsed, the minute minder emits a buzzer that will
GB
automatically stop after 30 seconds or when any active button on the control
panel is pressed.
To adjust the minute minder, proceed as follows:
1. Press the
icon.
2. Set the desired time using the control dial.
3. Once you have reached the desired value, press the
When the oven is switched off, the countdown appears on the display. When the
oven is on, the lit
symbol will remind you that the minute minder is active.
To cancel the minute minder, press the
set the time to 00:00. Press
The
icon will switch off to indicate that the minute minder has been
disabled.
Starting the oven
1. Press
to switch on the control panel. The appliance buzzer sounds
three times (ascending).
2. Press the
icon to select the desired manual cooking mode. The cooking
temperature and duration may be set.
Press the
icon to select the desired automatic cooking mode. The
cooking temperature and duration are both set to default values. Only the
duration may be adjusted in accordance with the selected mode. The text
"AUTO" appears on the display to indicate that the temperature is following
a precise cooking profile. A delayed cooking cycle may be programmed.
3. Press
to start the cooking mode.
4. The oven will begin its preheating phase, the preheating indicators will light
up as the temperature rises.
5. When the preheating process has finished, a buzzer sounds and all the
preheating indicator lights show that this stage has been completed: the food
can then be placed in the oven.
6. During cooking it is always possible to:
- adjust the temperature by pressing the
confirming by pressing
- set the duration of a cooking mode (see Cooking Modes);
- stop cooking by pressing the
the temperature modified previously in its memory (manual modes only);
- switch off the oven by pressing the
7. If a blackout occurs while the oven is already in operation, an automatic system
within the appliance will reactivate the cooking mode from the point at which it was
interrupted, provided that the temperature has not dropped below a certain level.
Programmed cooking modes which have not yet started will not be restored and
must be reprogrammed (for example: a cooking mode has been programmed
to start at 20:30. At 19:30 a blackout occurs. When the power supply is restored,
the mode will have to be reprogrammed).
! There is no preheating stage for the GRILL mode.
! Never put objects directly on the bottom of the oven; this will prevent the
enamel coating from being damaged.
! Always place cookware on the rack(s) provided.
28
icon again.
icon and use the control dial to
again.
icon, turning the control dial and
again (manual modes only );
icon. In this case the appliance stores
icon for 3 seconds.
Cooling ventilation
In order to cool down the external temperature of the oven, a cooling fan
blows a stream of air between the control panel and the oven door, as well as
towards the bottom of the oven door. At the beginning of the cleaning cycle,
the cooling fan operates at low speed.
! Once cooking has been completed, the cooling fan continues to operate
until the oven has cooled down sufficiently.
Oven light
The light comes on when the oven door is opened or when a cooking mode
starts (if enabled in the settings menu).
When models featuring LED INSIDE technology begin cooking, the LEDs on
the door light up for improved illumination of all cooking levels.
Residual heat indicators
The appliance is fitted with a residual heat indicator. When the oven is off,
the "residual heat" bar on the display lights up to indicate high temperatures
inside the oven cavity. The individual segments of the bar switch off one by
one as the temperature inside the oven falls.
Demo mode
! The appliance will not enter DEMO mode if the language has not been
selected beforehand.
The oven can operate in DEMO mode: all heating elements are deactivated,
and the controls remain operative.
To activate DEMO mode, switch off the oven and keep the control dial turned
clockwise while pressing
for 10 seconds. A buzzer sounds and the
display shows "DEMO".
To deactivate DEMO mode, keep the control dial turned anticlockwise while
pressing
for 3 seconds. A buzzer sounds to confirm deactivation.
Restoring the factory settings
The oven factory settings can be restored to reset all selections made by the
user (language, tone, customised durations, etc...). To carry out a reset, switch
off the oven, then press and hold 6
for 6 seconds. Once the restore procedure is complete, a buzzer will sound.
The first time the
icon is pressed, the oven will behave as if it is being
switched on for the first time.
Standby
This product complies with the requirements of the latest European Directive
on the limitation of power consumption in standby mode. If no buttons are
pressed for 30 minutes and the control panel/door lock has not been activated,
the appliance automatically reverts to standby mode. The ECO Mode symbol
appears on the display to indicate standby mode. As soon as interaction with
the machine resumes, system operation is restored.
,
and
simultaneously

Publicidad

loading