Philips Saeco Xelsis SM7786 Manual Del Usuario página 16

English
16
Warning icons and error codes
Meaning of the warning icons
Fill the water tank with fresh water
to the MAX level indication.
The bean hopper is empty. Put new
coffee beans in the bean hopper.
The brew group is not inserted or is
not inserted correctly. Insert the
brew group and make sure that it
locks into place.
The coffee grounds container is full.
Make sure that the machine is
switched on. Then remove and
empty the coffee ground container.
Meaning of error codes
Below you find a list of the error codes showing problems that you can solve yourself. Video
instructions are available on www.saeco.com/care. If another error code appears, please contact the
Philips Consumer Care Center in your country. For contact details, see the warranty leaflet.
Error Problem
code
01 The coffee funnel is
clogged.
03 The brew group is dirty
or not well-greased.
04 The brew group is not
positioned correctly.
Possible solution
Switch off the machine and unplug it. Remove the brew group.
Then open the lid of the pre-ground coffee compartment and
insert the spoon handle. Move the handle up and down until
the clogged ground coffee falls down (Fig. 27). Visit
www.saeco.com/care for detailed video instructions.
Switch off the machine with the main switch. Rinse the brew
group with fresh water, let it air-dry and then lubricate it.
Consult chapter 'Cleaning the brew group' or visit
www.saeco.com/care for detailed video instructions. Then
switch the machine on again.
Switch off the machine with the main switch. Remove the brew
group and reinsert it. Make sure that the brew group is in the
correct position before you insert it. Consult chapter 'Handling
the brew group or visit www.saeco.com/care for detailed
video instructions. Then switch the machine on again.
The machine needs to fill the water
circuit with water. Make sure there is
water in the water tank and press the
start/stop button to start.
Close the service door.
The internal cappuccinatore is not
inserted or is not inserted correctly
and/or the spout door is open. Make
sure that the holes in the
cappuccinatore are aligned with the
tubes in the machine before you
push the internal cappuccinatore
upwards into place. Then close the
spout door.
The coffee grounds container is not
in place. Place back the coffee
grounds container.