Publicidad
Idiomas disponibles
Idiomas disponibles
o
an
How to Use the Cruise Control
To engage the cruise control:
1. Slowly push the speed control pedal forward to the
desired speed (Figure 11).
2. Pull up on the cruise control knob (Figure 12). Release
the speed control pedal. The unit should continue
traveling forward at the desired speed.
NOTE:The cruise control only operates in forward
speeds.
To disengagethe cruise control:
1. Push the speedcontrol pedal (Figure 11), OR
2. Push the brake pedal.
,_
WARNING: Do not engage the cruise control when
driving on slopes, or when people or animals are in
the vicinity.
\
Figure 12: Cruise control
A - Cruise Control knob
How to Drive in Reverse
1. Look to the rear.
2. Slowly push the speed control pedal to the REVERSE
position.
How to ChangeDirection
CAUTION:To change directions, do not use the left brake
pedal. Use only the speed control pedal.
1. Slowly remove your foot from the speed control pedal.
The speed control pedal will automatically return to the
NEUTRALposition.
2. When the unit stops, slowly move the speed control
pedal to the desired direction.
Speed Control Pedal Positions
The forward speed is controlled by the position of the speed
control pedal. The following chart provides functions along
with the pedal positions. Always operate the engine with the
throttle control in the FASTposition.
Function
Trimming
Snow Thrower
Bagging Grass
Normal Mowing
Easy Mowing
Snow Blade
Transport
Pull Behind
Attachments
Pedal Positon
1/3
1/3 to 1/2
1/2 to 2/3
1/2 to 3/4
FULL
1/3 to 1/2
Throttle Position
FastThrottle
How to Disconnect the Transmission
To push the unit, use the automatic drive disconnect to
releasethe transmission. The automatic drive disconnect is
located under the seat.
1. The engine must be off.
2. Raise the seat. The automatic drive disconnect is
under the seat.
3. Move and latch the automatic drive disconnect in the
PUSH position (Figure 13). The transmission is now
released and the unit can be pushed.
NOTE:In cold weather, the heavy viscosity oil in the
transmission will make the unit difficult to push.
4. To engage the transmission, unlatch the automatic
drive disconnect. The transmission is now connected
and readyto operate.
16
www.snapper.com
Publicidad
