Publicidad
Idiomas disponibles
Idiomas disponibles
.m
How to Checkthe FuelFilter
NOTE:Beforeyou replace the fuel filter or the fuel line, the
fuel tank must be empty.
If the fuel filter is dirty, the engine will run rough and have
less performance. Removethe old filter (Figure 29). Replace
the old filter with a new filter. Use an original equipment
part. See an authorized service dealer in your area.
Figure 29: Fuel filter
A - Fuelline
B- Clips
C- Fuel filter (example only)
Checkthe Tires
Checkthe air pressure in the tires. Tires with too much air
pressure will cause the unit to ride rough. Also, the wrong
air pressure will keep the mower deck from cutting level.
Recommended air pressure is 14 PSI (1 BAR) for both front
and rear tires.
Mower Deck Maintenance
How to Remove the Mower Deck
1. Push the PTOswitch down to the DISENGAGEposition.
2. Open the deck level position cover, and move the deck
lift lever to the level adjustment position (Figure 30).
,_
WARNING: The deck lift lever is spring loaded. Make
sure the deck lift lever is locked in the LEVEL
ADJUSTMENTposition.
3. Remove the hair pins and the washers from the
adjuster arms (Figure 31). See illustrations "C" and "D".
4. Remove the hair pins and washers from the suspension
links. See illustrations "A" and "B".
Figure 30: Deck tiff lever
A - Deck level position cover (partially hidden)
B - Deck level adjustment position
5. Disconnect the front hanger from the axle support. See
illustration "E".
6. Remove the mower drive belt from the clutch pulley.
See illustration "F".
7. Pull the mower deck away from the right side of the
unit.
8. To operate without the mower deck, move the deck lift
lever to the TOP position.
How to Install the Mower Deck
1. Push the mower deck under the right side of the unit.
2. Put the mower drive belt around the clutch pulley.
Make sure the "V" side of the mower drive belt is
against the clutch pulley. Also, make sure the mower
drive belt is not twisted. See illustration "F".
3. Attach the front hanger to the axle support with the
hanger rod. Fastenwith the fasteners as shown. See
illustration "E".
4. Make sure the mower drive belt is between the clutch
pulley and the two belt guides. See illustration "F".
5. Attach the suspension links to the lifter assembly.
Fastenwith the washers and hair pins. See illustrations
"A" and "B".
6. Attach the right and the left adjuster arms to the
suspension brackets. Fastenwith the washers and hair
pins. See illustrations "C" and "D".
7. Make sure the mower deck is level. See the instructions
on "How To Level The Mower Deck".
8. Checkthe operation of the PTOclutch. See the
instructions on "How To Adjust The PTO Clutch".
30
www.snapper.com
Publicidad
