Snapper 0 Serie Manual Del Usuario página 34

€:
.m
How to Replacethe Primary Mower Drive Belt
1. Remove the mower deck. Seethe instructions on "How
To RemoveThe Mower Deck".
2. Remove the three screws from the left pulley cover.
Remove the pulley cover (Figure 38).
3. To remove the primary mower drive belt from the left
mandrel pulley, slide the primary mower drive belt
between the left mandrel pulley and the belt guides.
4. Pull the belt retainer away from the idler pulley.
Remove the primary mower drive belt from the idler
pulley.
5. Remove the primary mower drive belt from the stack
pulley.
NOTE:Replacethe primary mower drive belt with an
original equipment belt from an authorized service
center.
6. Install a new primary mower drive belt. Put the belt
around the stack pulley. Make sure the primary mower
drive belt is inside of the belt guide.
7. Pull the belt retainer away from the idler pulley. Put the
flat side of the primary mower drive belt around the
idler pulley.
8. Make sure the "V" side of the primary mower drive belt
is against the mandrel pulleys as shown.
9. Make sure the primary mower drive belt is inside all the
belt guides.
10. Assemble the left pulley cover.
11. Install the mower deck. See the instructions on "How
To Install The Mower Deck".
12. Before you mow, check the PTOclutch. See the
instructions on "How To Adjust The PTO clutch".
How to Replacethe Secondary Mower Drive Belt
1. Remove the mower deck. See the instructions on "How
To Remove The Mower Deck".
2. Remove the primary mower drive belt from the stack
pulley (Figure 38).
3. Remove the two screws from the right pulley cover.
Remove the pulley cover.
4. Pull the idler pulley away from the secondary mower
drive belt. Remove the belt from the idler pulley.
5. Remove the secondary mower drive belt from the right
mandrel pulley.
6. Remove the secondary mower drive belt from the stack
pulley.
NOTE:Replacethe secondary mower drive belt with an
original equipment belt from an authorized service
center.
7. Install a new secondary mower drive belt. Put the belt
around the bottom of the stack pulley. Make sure the
secondary mower drive belt is inside the belt guide next
to the stack pulley.
8. Put the secondary mower drive belt around the right
mandrel pulley.
9. Pull the idler pulley toward the front. Install the flat side
of the secondary mower drive belt against the idler
pulley.
10. Make sure the "V" side of the secondary mower drive
belt is around the right mandrel pulley.
11. Assemble the right pulley cover.
12. Put the primary mower drive belt around the stack
pulley.
13. Install the mower deck. See the instructions on "How
To Install The Mower Deck".
14. Before you mow, check the PTOclutch. See the
instructions on "How To Adjust The PTO clutch".
34 www.snapper.com