Publicidad
Idiomas disponibles
Idiomas disponibles
How to Checkand Adjust the Drive Brake
Completely push the brake pedal forward. Set the parking
brake. Move the automatic drive disconnect to the PUSH
position. Push the unit. If the rear wheels rotate, adjust or
replace the brake pads. Adjust the drive brake as follows.
1. The location of the drive brake is on the right side of the
gearbox (Figure 26).
2. Make sure the parking brake is set and the automatic
drive disconnect is in the PUSH position. Turn the
hex nut in a clockwise direction until the rear wheels do
not turn when the unit is pushed forward.
3. Releasethe parking brake and push the unit. If the unit
does not roll, turn the hex nut in a counterclockwise
direction until the unit rolls.
4. Set the parking brake. Push the unit. If the rear wheels
do not turn, the drive brake is correctly adjusted.
Releasethe parking brake.
_
WARNING: If you cannot correctly adjust the drive
brake, replace the brake pads. Correct replacement
parts and assistance are available from an authorized
service center.
Figure 26: Adjusting drive brake
A - Drive brake
B - Gearbox
C - Hex nut
w.
CD
¢D
English
27
Publicidad
