Publicidad
Idiomas disponibles
Idiomas disponibles
Service: Manually Initiated Electronic Diagnostics
Turbine
Switches
[] To enter diagnosdcs, press and hold [l_e SEI.ECT bullon undl (000 - -) showsin [lie display
_rl m
A The firsl 3 digils indicale waler meter operadon
as iollows:
IOR P
• 000 (sleady) = soft waler no[ in use_.no flow din)ugh [lie meter.
--OPEN A NEARBY SOFTWATER FAUCET--
Water
Switch(B)
Meter (A)
• 000 tO 199 (condnual)
= repeats displ_ly ior each gallon of water passing through tl_e meter.
swi!c/
Sensor
1 _ _)'-housing
I !_Tu[b
ine
_Turbine
Valve
t_'_l_"
Support &
ou!,e!
sha,
If you don't get a reading
in die display, wid_ faucet
open,
pull die sensor from d_e; al',e omlet
porL Pass
a small magnet
back and fbrth in flonl of the sensor. You should
get a reading
in the display. If you get a
reading,
shin of{waler
supply, unhook
[lie in and ouI plumbing
and (hetk
die [urbine
ior binding.
BThe letter (P) and dash (es) indicate POSITION swhch operation. The letter appeming
means tl_e
s_4t(;h is closed; d_e dash means tl_e swhch is open. Use the TOUCHor HOLB(RECHARGETONI6HT-
RECHARGE NOW)buuon to mamlally advance die valve imo each Q,cle and check corred switch
operation.
CORRECT SWITCH
DISPLAYS
Ep
VALVE CYCLE STATUS
Valve in service,fill, brining,backwash
or fast rinse position.
Valve rotating from one positionto another
CWhile in this diagnostic screen, the fi)llowing infi)rmation is available and may be benefidal
for various
reasons. This intormation
is retained by the computer fiom the first time electrical power is applied to
the control.
• Press and hold the UP button to display the number of days this control has had electrical power
applied.
• Press and hold the DOWN button to display the number of regenerations
initiated by this control
since the SR code number was entered.
F_ Press the SELECTbuttonand hold in three seconds until a Service Rating code appears in the display.
Repeat this step if the SR code is not displayed.
For correct water softening system operation,the SRnumbermustbe as follows:
GXSF27
SR22
GXSF39
SR31
GNSF35
SR35
Toresetthe code,press the L l or DO'vVN button until the correct number shows.
_] Press SELECT to rettlrn to the present time display, tithe cede was changed, m ake ALLthetimersettings.
NOTE: If the (ontrol is left in a diagnosti( display or a flashing display when setting times or hardness,
present time automatically returns ifa button is not pressed within ti)tli minutes.
/5
Publicidad
