16. INSTALL THE BLOWER (EXTERIOR OR IN-LINE BLOWER)
Refer to instructions included with blower.
Plug
the
3-prong
plug
cord
from
rough-in
plate
to
the
3-prong
male
connector inside the hood (A) and the 2-prong male connector cord from rough-in
plate to the 2-prong plug inside the hood (B).
o
not plug the 2 cords together.
|
17. REINSTALL GREASE DRIP RAIL AND BAFFLE FILTERS
Reinstall grease drip rail. The illustration at right shows how to reinsert the grease
drip rail into the range hood.
HD0244
Remove protective plastic film covering fillers before installing them.
NOTE:Assemble
the
metal
handles
to the
filters,
using
provided
no.
8-32
x 1/4" screws,
before
installing them in the hood.
It
is
recommended
to
install
side
filters first and finish with center one(s).
1.
Insert one end of the filter into the
upper channel of the hood.
2.
Raise
the
other
end
toward
the
inside of hood
and
insert in the
a
yo
grease drip rail of the hood.
HDo24s
18. INSTALL LIGHT BULBS
This hood requires 50 W, 120 V with GU10 base, shielded halogen bulbs (not included). (2 required for 30" and 36" hood widths
or 3 for 42" and 48" hood widths.)
Do not touch lamps during or soon after operation. Burns may occur.
SN
In order to prevent the risk of personal injury, only install shielded
halogen lamps. Also, never install a cool beam, a dichroic lamp, a
lamp not suitable for use in recessed luminaires or identified for use
in enclosed fixtures.
HOOO9O
1. Install bulbs by placing the bulb leads into their grooves in the socket.
2. Gently push upwards and turn clockwise until secure.
To remove bulbs, gently push upwards and turn counterclockwise to disengage bulb leads from their grooves.
NOTE: If need be, use a rubber dishwashing glove to add grip when removing the bulb.
-412-