Publicidad
Idiomas disponibles
Idiomas disponibles
7. Take out the left upper hinge, left upper hinge cover, and right decorative
cover from the accessory bag. Install the freezer door on the middle hinge, and
install the left upper hinge, left hinge cover and hole cap. Finally, install the right
decorative cover on right side of the end cap of freezer door.
2.4. Changing the Light
2.5 Starting to use
700mm
125
1078mm
2.6 Energy saving tips
• The appliance should be located in the coolest area of the room, away from
heat producing appliances or heating ducts, and out of the direct sunlight.
•
Let hot foods cool to room temperature before placing in the appliance.
Overloading the appliance forces the compressor to run longer. Foods that
freeze too slowly may lose quality, or spoil.
• Be sure to wrap foods properly, and wipe containers dry before placing them
in the appliance. This cuts down on frost build-up inside the appliance.
• Appliance storage bin should not be lined with aluminum foil, wax paper, or
paper toweling. Liners interfere with cold air circulation, making the appliance
less efficient.
•
Organize and label food to reduce door openings and extended searches.
Remove as many items as needed at one time, and close the door as soon as
possible.
Upper left hinge cover
Upper left hinge
Any replacement or maintenance of the LED lamps is
intended to be made by the manufacturer, its service agent
or similar qualified person.
1. Please take out
the plug before
removal.
3. Take down the
lamp panel.
Before initial start, keep the refrigerator still for half an
hour before connecting it to power supply.
Before putting any fresh or frozen foods, the refrigerator
shall have run for 2-3 hours, or for above 4 hours in
summer when the ambient temperature is high.
Spare enough space for convenient opening of the
doors and drawers or statement by the distributor.
Sensor
Hole cap
The pictures above are only for
reference. The actual configuration will
depend on the physical product or
statement by the distributor.
2. Remove the
lampshade with a
screwdriver.
4. Remove the
connection terminal.
13
V.1
Publicidad
