IPC CT110 BT70 Roller Manual De Instrucciones página 65

MICROFIBRE with microfibre disk. The LED corresponding to the operating mode
selected (BRUSH-PAD, or MICROFIBRE) lights up.
•
Select the most suitable pressure for the head on the floor according to the type of
washing to be performed using the buttons (fig. A, ref. 7).
•
Select the most suitable flow according to the type of washing to be performed using
the button (fig. A, ref. 3). There are five options
1 STANDARD, the solution flow can be modified using the buttons (fig. A, ref. 2)
(STANDARD MACHINE ONLY)
2 AUTOMATIC, the solution flow is set by the machine according to the speed
(STANDARD MACHINE ONLY).
3 ECONOMY, the solution flow is fixed at the lowest level (STANDARD MACHINE
ONLY).
4 CHEM-DOSE
(OPTIONAL). To enter CHEM-DOSE mode, hold the button (fig. A, ref. 3) down
until the red LED corresponding to CHEM-DOSE comes on. To vary the quantity
of solution, you must first disable the programmes (STANDARD, AUTOMATIC,
ECONOMY) by pressing the button (fig. A, ref. 3). The quantity of solution can
now be adjusted using the buttons (fig. A, ref. 2) and the value set appears on the
display (fig. A, ref. 6). Once the quantity of solution has been set, the most
suitable type of solution flow must be selected (STANDARD, AUTOMATIC,
ECONOMY) using the button (fig. A, ref. 3). To disable the solution tank pump,
hold the button (fig. A, ref. 3) down for at least five seconds until the LED
corresponding to CHEM-DOSE goes out.
5 CHEM-DOSE MICRO SCRUB / ECS MACHINE enables the solution tank pump
(OPTIONAL). To enter CHEM-DOSE mode, hold the button (fig. A, ref. 3) down
until the red LED corresponding to CHEM-DOSE comes on. To vary the quantity
of solution, you must first disable the programmes (STANDARD, AUTOMATIC,
ECONOMY) by pressing the button (fig. A, ref. 3). The quantity of solution can
now be adjusted using the buttons (fig. A, ref. 2) and the value set appears on the
display (fig. A, ref. 6). Once the quantity of solution has been set, for BRUSH-PAD
mode only, the most suitable type of solution flow must be selected (STANDARD,
AUTOMATIC, ECONOMY) using the button (fig. A, ref. 3). When using CHEM-
DOSE in MICROFIBRE mode, you cannot use the STANDARD, AUTOMATIC and
ECONOMY programmes. To vary the flow, use the buttons (fig. A, ref. 2) only. To
disable the solution tank pump, hold the button (fig. A, ref. 3) down for at least five
seconds until the LED corresponding to CHEM-DOSE goes out.
6 MICROFIBRE, the solution flow can be varied using the buttons (fig. A, ref. 2)
(MICRO SCRUB / ECS MACHINE ONLY)
•
Start cleaning, manoeuvring with the hands on the steering wheel (fig. B, ref. 9) and
moving the machine forwards or backwards by pressing the pedal (fig. B, ref. 7).
•
The working speed can be set using the maximum speed regulator (fig. A, ref. 13).
•
Models with roller brushes: empty the debris bin (fig. O, ref. 5) by extracting it
sideways. Empty the debris and wash.
To avoid damaging the surface of the floor to be treated, avoid rotating the
brushes/pads/microfibre disks with the machine stationary.
Stopping:
•
Release the pedal (fig. B, ref. 7)
STANDARD MACHINE, enables the solution tank
IMPORTANT
pump
ENGLISH
17