Publicidad
Idiomas disponibles
Idiomas disponibles
!Foubleshoot)ng
Won't Fill
Won't Agitate
• Plug Cord into live electrical outlet
• Check fuse or reset circuit breaker
• Turn tbe control dial to proper cycle and restart the washer
• Turn both faucets on fully
• Straighten inlet hoses
• Disconnect hoses and clean screens, Hose filter screens may be plugged.
• Check fuse or reset circuit breaker.
• Make sure the lid is completely closed
• Turn the control diaf to proper cycle and restart the washer.
• Pauses are normal, Wait and see if the washer wilt start again,
Won't Spin
or Drain
Load is Wet
Stops
Leaks Water
• Check fuse or reset circuit breaker.
• Straigllten drain I_oses Eliminate kinked hoses If there is a home drain restriction, call for drain
service
• Close lid and restart the washer For your safety, washer wil! not spin unless the lid is closed
• Suds lock - caused by too much suds Rewash without detergent Use correct amount of a low-
sudsing detergent,
Unevenly distributed load Redistribute the load, close timelid and restart the washer, Check for
leveling Be sure water fevel is acceptable for load size
A normal spin speed is recommended for hea_ loads like jeans or towels,
Plug cord into live electrical outlet..
Check fuse or reset circuit breaker
o Close lid and restart the washer For your safety, washer will not agitate or spin unless lid is closed
• This may be a pause in the cycle. Wait briefly and it may start
- Make sure hose connections are tight
• Make sure end of drain hose is correctly inserted and secured to drain facility
• Avoid extended soaking - soak for 30 minutes or less.
• Avoid overloading.
Is Noisy
- Be sure washer is leveled properly as outlined in installation manual
• Weak floors can cause vibration and walking.,
• Operating sounds will vary depending on agitation speed
Fills with the Wrong
Temperature Water
• Turn both faucets on fully
• If equipped with a temperature selector knob, be sure it is set directly on a temperature setting and
not between settings
• Make sure temperature selection is correct
• While the washer is filling, you may notice just hot and/or just cold water entering the tub when
cold or warm wash temperatures are selected This is a normal function of tile Automatic
Temperature Control (select models) feature as timewasher determines timetemperature of the
water
• if Auto Temperature Control [select models) is selected, cold water may feel warmer than cold
water from the tap.
• Make sure hoses are connected to correct faucets and inlet connections Be sure water supply is
regulated correctly Flush water line before filling washer.
• Check the water beater It should be set to deliver a minimum ]20 ° F C49 ° C) hot water at the tap
Also check water heater capacity and recovery rate.
• Disconnect hoses and clean screens Hose filter screens may be plugged
Cycle Selector
• Extra Rinse [select models) is selected
Advances Through
Off
For further assistance_ carl Maytag CustomerAssistance tuff-free at 1-800-688-9900 USA or 1-800-688-2002 Canada,
::
:
U.S.customersusing TrY for deaf, hearing impaired or speech impaired, call 1-800-688-2080,
t2
Publicidad
