Publicidad
Idiomas disponibles
Idiomas disponibles
Usin9 theControls - |lectronic C ontrol Models
Getting Started
1 Add detergent
and additives to tile washer
2 Load the washer.
3. Close the lid.
4. Select the appropriate
cycle and options for the load.
5. Press the cycle selector' dial.
6 The Fill indicator
light will illuminate
and the washer will start to fill1
!
Note:
The lid must be completely
closed in order
t
to operate the washer controls.
1
In_ni_:e Wa_er Level
Extra 9i n_e
Select Water Level
Determine
the selected setting based on clothes load
size,. Selection should provide sufficient
water to permit
clothes to circulate freely during agitation..
It may become necessary, due to bulky fabrics, to
adjust the water level after agitation
begins. To adjust
the water level, turn the Infinite Water Level control to
reset and then back to the desired setting
LEVEE smiNG
i
Mini
I/4 Full
Small
Medium
Large
Super
1/4-
1/3
1/3-
1/2
1/2 - 2/3
3/4 - Full
Note:
Items must circulate freely for best results.
Select Wash/Rinse Temperature
Your washer gives you a choice of hot, warm or cold
water for washing
and cold water for rinsing
Use the
chart below as a guide.
Automatic
Temperature
Control (A.T.C.)
provides
the optimal wash water temperature
for cleaning
To
save energy, this washer will regulate wash water
temperatures
by mixing hot and cold water to reach
the proper water temperature;
ATC Cold/Cold
Note:
In wash water temperatures
below 60° F,
detergents
do not dissolve well or clean well
Brightly colored, lightly soiled
Cold/Cold
items;
washable woolens.
These settings feature Automatic Temperature Control:
ISaves energy by adding cold water
ATC But/Cold
to the hot water from your water
ATe Warm/Cold
heater. Provides optimum
cleaning
at lower temperatures.
May add hot water to the incoming
cold water as the washer fills.. This
assures
that the water will be warm
enough to properly activate detergent
Publicidad
