Weber Genesis 320 Guia Del Propietario página 22

PROBLEM
Burners burn with a yellow or orange flame, in
conjunction with the smeim of gas.
Burner does not might, or flame is mowin Hi position.
Burner does not ignite when you push the igniter
button.
Experiencing flare-ups:
CAUTION: Do not line the slide out
grease tray with aluminum foil.
CHECK
Inspect Spider/Insect screens for possible obstructions.
(Blockage of holes.)
Is fuel hose bent or kinked?
Be sure that there is gas flow to the burners by
attempting to match light your burners. Refer to "MAIN
BURNER MANUAL IGNITION'.'
is there a fresh battery installed?
Are the wires connected properly to the ignitior module?
is there plastic wrapping around the new battery?
Are you preheating barbecue in the prescribed manner?
Are the cooking grates, heat deflectors and Flavorizer _
bars heavily coated with burned-on grease?
is the slide out grease tray dirty and not allowing grease
to flow into catch pan?
Are burners clean?
SOLUTION
Clean Spider/Insect screens. Refer to 'ANNUAL
MAINTENANCE'.'
Straighten fuel hose.
if match lighting is successful, the problem lies in the
ignition system. Refer to "ELECTRONIC IGNITION
SYSTEMS OPERATIONS'.'
Verify that the battery is in good condition and installed
correctly. Refer to "ELECTRONIC IGNITER INSPECTION".
Be sure that wires are correctly inserted into terminals
on ignition box. Refer to "ELECTRONIC IGNITION
SYSTEMS OPERATIONS'.'
Remove plastic wrapping.
All burners on HI for 10 to 15 minutes for preheating.
Clean thoroughly. Refer to "CLEANING'.'
Clean slide out grease tray.
Burner flame pattern is erratic. Flame is low when Clean burners. Refer to "MAINTENANCE'.'
burner is on HI. Flames do not run the whole length
of the burner tube.
Inside of midappears to be "peeling." The inside of the lid is porcelain enamel or stainless Clean thoroughly. Refer to "CLEANING'.'
(Resembles paint peeling.) steel, and is not painted. It cannot "peel'.' What you are
seeing is baked on grease that has turned to carbon and
is flaking off.
THIS IS NOT A DEFECT.
Cabinet doors are not aligned. Check the adjustment pin on the bottom of each door. Loosen adjustment nut/s. Slide dooris until aligned.
Tighten nut.
If problems cannot be corrected by using these methods, please contact the Customer Service Representative in your area using the contact information on our
web site. Log onto www.weber.com _.
PROBLEM CHECK SOLUTION
Side burner does not light. Is gas supply off? Turn supply on.
Flame is low in HI position. Is the fuel hose bent or kinked? Straighten hose.
Push button ignition does not work. Does burner light with a match? if match lights burner, check igniter. Refer to "SIDE
BURNER MAINTENANCE'.'
If problems cannot be corrected by using these methods, please contact the Customer Service Representative in your area using the contact information on our
web site. Log onto www.weber.com e_.
22