Stihl RE 80.0 Manual De Instrucciones página 39

8 Connecting the pressure washer to the power supply
NOTICE
■ If the high-pressure washer does not suck in
water, the pump may run dry and the high-
pressure washer may be damaged.
► If no water escapes from the high-pressure
hose after two minutes: Switch off the high-
pressure washer and check the water sup‐
ply.
► Switch off the high-pressure washer.
► Connect the spray gun to the high-pressure
hose.
► Press and hold down the spray gun trigger.
► Switch on high-pressure washer.
8 Connecting the pressure
washer to the power supply
8.1 Connecting the High-Pressure
Washer to an Electric Power
Supply
1
► Move the rocker switch (1) to the 0 position.
► Remove the connecting cable (3) from the
holder (2).
► Plug the connecting cable (4) into a properly
installed socket.
9 Switching the pressure
washer on and off
9.1 Switch on high-pressure
washer
When the pressure washer is switched on, volt‐
age fluctuations may occur under unfavorable
mains conditions. The voltage fluctuations may
negatively affect other connected electrical appli‐
ances.
0458-001-8721-B
2
3
4
► Set the rocker switch to position I.
9.2 Switching off the pressure
washer.
► Set the toggle switch to the 0 position.
10 Operating the pressure
washer
10.1 Holding and controlling the
spray gun
► Hold the spray gun by the handle with one
hand, wrapping your thumb around the han‐
dle.
► Hold the spray lance firmly with your other
hand, wrapping your thumb around the spray
lance.
► Point the nozzle at the ground.
English
39