11 After Finishing Work
► Fill the bottle (1) with maximum 500 ml of the
detergent.
► Screw the spray nozzle (2) onto the bottle (1)
and tighten firmly by hand.
4
► If a nozzle is attached to the spray lance (3):
Remove the nozzle.
► Attach the spray set (4) to the spray lance (3).
► Soak extremely dirty surfaces with water
before cleaning them.
► Press the spray gun lever and spray the deter‐
gent onto the surface to be cleaned.
► Apply the detergent starting at the bottom and
working up and do not allow to dry.
► Remove the spraying set.
► Attach the nozzle.
► Clean the surface.
11 After Finishing Work
11.1
When Work is Finished
► Switch off the high-pressure washer and pull
the mains plug out of the socket.
► If the high-pressure washer is connected to
the water supply: Turn off water supply.
► Press the spray gun trigger.
The water pressure is reduced.
► Lock the spray gun trigger.
► Disconnect the high-pressure washer from the
water source.
► Remove the water hose.
► Remove the high-pressure hose and let the
rest of the water run out of the high-pressure
hose.
► Remove and clean the nozzle and spray
lance.
► Remove the spray gun and let the rest of the
water run out of the spray gun.
► Clean the high-pressure washer.
0458-001-8721-B
3
1
7
6
► Roll up the high-pressure hose (1) and hang it
on the holder (2).
► Coil the connecting cable (3) on the holder (2).
► Secure the connecting cable (3) using the clip
(6).
► Insert spraying set (5).
► Insert the nozzles (7).
► Store the spray attachment in the holders (4)
on the high-pressure washer.
11.2
Protecting the pressure washer
with antifreeze
If the pressure washer cannot be protected from
frost during transport or storage, the pressure
washer should be protected by a glycol-based
antifreeze. The antifreeze prevents water inside
the pressure washer from freezing and causing
damage to the pressure washer.
► Remove spray lance
► Connect the shortest possible water hose to
the pressure washer.
The shorter the water hose, the less antifreeze
is needed.
► Mix the antifreeze as described in the anti‐
freeze Instruction Manual.
► Pour antifreeze into a clean container.
► Insert water hose into container of antifreeze.
► Squeeze and hold spray gun trigger.
► Switch on pressure washer.
► Hold down spray gun trigger until an even jet
of antifreeze is delivered from the spray gun
and point the spray gun into the container.
English
2
3
4
5
41