Publicidad
Idiomas disponibles
Idiomas disponibles
OBJ_BUCH-0000000419-001.book Page 10 Thursday, November 19, 2020 12:08 PM
Rebate cut: Pull the cutting bar 3 out and fold out the
depth limiter 2. Set the rebating depth. Perform the
rebate or separation cut in the insulation panel by mov-
ing the cutting bar 3 to the set depth.
Use with Guardrail-holder
(see figure C)
Suitable for upright operation of the device while
attached on a scaffold guardrail.
Mount the strap 12 around the scaffold guardrail.
Standalone Usage (Optional)
(see figure D)
Pivot the leg 13 out and insert the brace into the angle.
Maintenance and Cleaning
Before any work on the device itself, pull
the mains plug from the socket outlet.
Retighten all bolts and nuts once a year, and always
before putting into operation. Clean the wire-guide roll-
ers and the ball tracks and check their easy-running.
Replace the heating wire when heavily soiled (encrus-
tations).
Use only dry means for cleaning; do not use solvent.
When the device is put out of operation for longer peri-
ods, clean it and store in a protected location.
Calibration
Support angles, left and right: Loosen nut 14
with an open-end spanner and align the supporting rail
by turning bolt 15. Then tighten the nut again.
(see figure E)
If the device should fail, despite the care taken in man-
ufacturing and testing procedures, repair should be
carried out by a Würth masterSERVICE.
In all correspondence and spare parts orders, please
always include the article number given on the type
plate of the device.
The current spare parts list for this device can be
viewed on the Internet at
"http://www.wuerth.com/partsmanager" or be
requested from your next Würth branch office.
Guarantee
For this Würth device, we provide a guarantee in
accordance with the legal/country-specific regulations
from the date of purchase (verified by invoice or deliv-
ery document). Damage that has occurred will be cor-
rected by replacement or repair.
Damage caused by normal wear, overloading or
improper handling is excluded from the guarantee.
Claims can only be accepted if the device is sent undis-
assembled to a Würth branch office, your Würth sales
representative or an authorised customer service agent
for Würth compressed-air and power tools.
Disposal
The device, accessories and packaging should be
sorted for environmental-friendly recycling.
Do not dispose of the device into household waste!
Only for EC countries:
According to the European Guideline
2012/19/EU for Waste Electrical and
Electronic Equipment and its implemen-
tation into national right, power tools
that are no longer usable must be col-
lected separately and disposed of in an environmen-
tally correct manner.
Subject to change without notice.
10
Publicidad
