STEINEL L 830 SC Manual Del Usuario página 36

Luminous intensity distribution (Fig� 3�9, Fig� 3�10, Fig� 3�11, Fig� 3�12)
Reach (SC only) (Fig� 3�13)
Note: If lights are mounted too close together, switching errors may occur as
the high-frequency signals emitted will interfere with each other. (Fig� 3�14 A)
The following measures will help to avoid switching errors of this kind:
• Allow a distance of at least 5 m between lights.
• Interconnect lights via the Steinel Connect App and selectively deactivate
the sensor in individual lights via the Sensor-Off function (Fig� 3�14 B + C).
As a result of interconnection, movement will also switch lights ON in spite
of their sensor being deactivated.
4� Electrical connection
Wiring diagram (Fig� 4�1)
The mains supply lead is a 2 to 3-core cable:
L = phase conductor (usually black or brown)
N = neutral conductor (usually blue)
PE = protective-earth conductor (green / yellow)
If you are in any doubt, identify the conductors using a voltage tester; then
disconnect from the power supply again. Connect phase (L) and neutral
conductor (N) to the terminal. Insulate protective-earth conductor (PE) and
place it next to terminal block.
For GL 80 SC / C, the protective-earth conductor must be connected to the
earth terminal (PE).
Important: Incorrectly wired connections will produce a short circuit later on in
the product or your fuse box. In this case, you must identify the individual
cables and re-connect them. A mains power switch for turning the light ON
and OFF may of course be installed in the mains supply lead.
Important: The light source of this luminaire cannot be replaced. If the light
source needs to be replaced (e.g. at the end of its service life), the complete
luminaire must be replaced.
– 36 –