STEINEL L 830 SC Manual Del Usuario página 39

GB
Factory settings (state on leaving the factory)
– Reach setting = max.
– Main light time setting: 10 sec.
– Basic light time setting: 1 min.
– Twilight level: 2,000 lux
– Basic light dimming level: 50 %
Reach setting (sensitivity)
Reach is the term used to describe the diameter of the more or less circular
detection zone produced on the ground after mounting the sensor-switched
light at a height of 2 m.
– Control dial set to maximum = max. reach (5 m)
– Control dial set to minimum = min. reach (1 m)
This function only ever applies to the C types in combination with a Bluetooth
sensor-switched product.
Twilight setting (response threshold)
The chosen response threshold can be infinitely varied from approx. 2 to
2,000 lux.
– Control dial turned fully clockwise = daylight mode (depending on ambient
brightness)
– Control dial turned fully anti-clockwise = twilight operation (approx. 2 lux)
This function only ever applies to the C types in combination with a Bluetooth
sensor-switched product.
The control dial must be turned fully clockwise when adjusting the detection
zone and performing the walk test in daylight.
Basic lighting level
The brightness of the basic light level setting can be varied between 0 % and
100 %. Basic light can be set in relation to time or ambient light level.
The light switches to maximum output (100 %) for the time selected in res-
ponse to movements in the detection zone. The light then returns to the basic
light level.
Main light level
The brightness of the main light level setting can be varied between 10 % and
100 %.
Soft light start function
On switching ON, light level constantly builds up to 100 % (fade in).
On switching OFF, light level is constantly reduced to 0 %
(fade out). Fade-in and fade-out times are selectable.
– 39 –