Publicidad
Idiomas disponibles
Idiomas disponibles
3) Align the rear wheel shaft with car body and pass through the hole on
both sides.
"L" motor is installed at left side, "R" motor is installed at right side. Then
insert motor joint and install one wheel which already is installed plum
blossoms well on left/right both sides of rear wheel shaft respectively, (One
side of the drive plum blossom inward match with gear box).
4）Then place one M10 washer on both sides, use one M10 anti loose nut to
fix .Press the wheel cover on the wheel.
10
3.Install car door and steering wheel
Install the car door and steel sheet: Loosen the fixing screws on
①
both sides of the instrument panel, align the door with the car body,
then insert the steel sheet on the door into the instrument panel and
tighten the fixing screws on the instrument panel.
Install steering wheel: Push into steering wheel after SM terminal
②
on steering wheel is aligned and inserted well with SM terminal of
body, then align the steering wheel then insert it into car and hook it
well, don't fiercely beat the key of steering wheel during assemble
process. (please note that the wire can't be seized during
installation)
EN
11
Publicidad
