Publicidad
Idiomas disponibles
Idiomas disponibles
3.Installation and using of the storage battery of remote
controller
① Install battery:open the battery cover which is in the remote control,
install two pieces of AAA (1.5V)(#7)dry batteries, pay attention to the
polarity of battery before installing. Put on the battery cover and use screws
to fix(Please follow the steps above to replace the battery. Only adults can
replace it.) Please don't mix the new and old batteries or different batteries.
Please take away the exhausted batteries from the toys in time.)
② Using Method
a.This product needs to match code when first using. Replace battery or
restart don't need to match code.
b.Press "A" & "V" keys for 3 seconds at the same time to start matching
code. The first LED light flickers.
c. Turn the car body power on, and the first LED lights up. Match code
succeeds. Press and hold the remote control for 10 seconds (if it is not
running), it will be in standby mode. Press any key to wake it up.
d.Keys caption: "
" Forward, "
Brake. Press "S" key to accelerate (1 LED light at low speed, 2 LED lights at
medium speed, and 3 LED lights at high speed). The car only has a low
speed in the reverse mode. Press the "P" key and hold down the brake, all
LED lights will flash.
16
"Back,"
" Left,"
" Right, "S" Speed, "P"
WARNING!
1.Not for children under 3 years old. Small parts. Choking hazard.
2.The remote controller only can be used with adult's guidance.
3.Load two AAA(1.5V )batteries according to the diagram.
4.Non-rechargeable batteries are not to be recharged.
5.Different types of batteries or new and used batteries are not to be mixed.
6.Batteries are to be inserted with the correct polarity.
7.Exhausted batteries are to be removed from the toy.
8.The supply terminals are not to be short-circuited.
9.Should take away the exhausted batteries from the toys, and handle well,
prevent played by children and caused harm.
10.The packaging must be retained since it contains important information.
4.Use of the recoverable type fuse
This car uses 10A recoverable type fuse, it will automatically shut off the
power supply when the current exceeds 10A, automatically recover after
5-10 seconds.
10A
EN
17
Publicidad
