cecotec BOLERO COOLMARKET TT B1 121 E Manual De Instrucciones página 56

ENGLISH
2. With the door closed, remove the screws on the outside of the hinges. Open the door
hinges. With the hinge open, loosen the screws securing it to the refrigerator. Be careful
with the hinge, use a long shaft screwdriver if possible (Fig.4).
3. Remove the hinge and place it in the diagonally opposite corner of the refrigerator. Screw
it back on. Repeat with the other hinge. Refit the door and refasten the hinges. Check that
the door is aligned horizontally and vertically and that the seals are closed and securely in
place on all sides before tightening the bottom hinge screws (Fig. 5).
4. Replace the upper hinge protector (left and right). Replace the cover of the refrigerator's
lower screw hole. Replace the door screw hole cover (Fig. 6).
4. OPERATION
Use the appliance in accordance with the following control instructions. Figure 7 shows
-
the control panel icons and their corresponding functions.
For optimal food preservation, it is recommended to set the refrigerator temperature to
-
4°C during the first use. If you wish to change the temperature, follow the instructions
below:
Warning: Warning: when a temperature is set, this is an average temperature for the entire
refrigerator, the temperatures inside each compartment may vary from the temperature
shown on the control panel display, depending on how much food you store and where you
place it. A high or low ambient temperature can also affect the actual temperature inside the
appliance.
1. Switch-on
- Press and hold the "POWER"
- When the refrigerator is switched on, the display will show "- -". If no button has been
pressed, the display will turn off after approximately 1 minute.
- If you want to deactivate the power-on function, make sure that the control panel is
illuminated. If not, you can press any button to turn it on.
IMPORTANT!
- If the refrigerator is switched on but the display shows "- -", the appliance will stop
cooling.
- If you are not going to use the device for a long period of time, disconnect it from the
mains.
Fast Cooling function
2.
This function allows food to be cooled more quickly and kept cold for a longer period of
-
time. During this process, vitamins and nutrients are locked in the fresh food, making it
last longer.
56
button for 3 seconds to turn the device on or off.