Descargar Imprimir esta página

Porsche E-Performance Instrucciones De Instalación página 22

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 25
Appendix: Hilti Foundation Fastening Kit
Appendix: Hilti Foundation Fastening Kit
Hilti HVA: HVU M12x110 + HAS-R M12x110/168
Installation guide
1. Produce a hole with a hammer drill:
– Diameter: 14 mm
– Drilling depth: 110 mm
1
TIP: Use a Hilti hollow drill bit type TE-CD or TE-YD
with Hilti vacuum connection.
2. Clean the drill hole: Blow out coarse dust until
the exiting air is dust-free.
2
4x
– With a hand pump: Using the Hilti blow-out
pump, blow out the drill hole from the base
of the hole at least 4 times
– Compressed air cleaning (CAC): Blow out the
drill hole twice with oil-free compressed air,
from the base of the hole through its entire
3
length (min. 6 bar at 6 m
/h; use an extension
if necessary).
20
Information
Before inserting the pin, make sure the hole is free
from drilling dust and other impurities.
Poorly cleaned drill hole = low load-bearing capacity
3. Check the correct hole depth of 110 mm with
the aid of the marking on the anchor rod:
– The drill hole must not be deeper than the
embedment depth.
– If the embedment depth is inadequate,
make the drill hole deeper.
3
4. Insert the Hilti HVU anchor capsule (with plastic
bag) fully into the drill hole.
1 4
HVU
5. Screw the anchor rod into the anchor capsule
with the embedment tool under moderate
pressure, with the drill's hammer function
switched on (250 – 1000 rpm).
When the marked embedment depth is reached,
switch off the hammer drill.
1 5
HAS
HIS
6. Do not move the anchor rod during the curing
time t
.
rel
1 6
t
rel

Publicidad

loading