Kohler K-3396 Guia De Instalacion página 12

Operation (cont.)
increases above about 250°F (121°C), all 10 Power Setting LEDs start
flashing. If the temperature remains high for more than another two
minutes, the cook sink stops heating automatically.
Observe that, after a period of time, the hot pot indicator
illuminates.
Observe that, after a period of time, the water begins to boil.
Verify that the LEDs are not now flashing.
Press the power down button for several seconds to decrease the
temperature.
When the water has cooled significantly below boiling, drain the
cook sink.
Observe that, after a period of time, the hot pot indicator
extinguishes.
8. Clean Up
CAUTION: Risk of product damage. Do not use abrasives on
this product. Abrasive materials can scratch and ruin the surface
finish.
NOTE: Refer to your Homeowners Guide for detailed cleaning
instructions and recommended cleaners.
Remove any construction materials or debris.
Clean the sink with a non-abrasive cleaner.
Troubleshooting Guide
Troubleshooting Tips
NOTE: This troubleshooting guide is for general aid only. For
warranty service, contact your dealer or wholesale distributor.
Troubleshooting Table
Symptoms
1. The cook sink does
not hold water.
1032055-2-B
Recommended Action
A. Operate the drain by turning the drain
knob open and closed several times. Then,
close the drain.
12 Kohler Co.