Kohler K-3396 Guia De Instalacion página 8

Control Box
Junction Box
Screws
3. Install the Sink
CAUTION: Risk of product damage. Use care to avoid
damaging the cooking vessel components when you lift the sink
into place.
Remove the two screws from the junction box cover and remove
the cover. Save the screws and cover.
Remove the four screws from the control box lower cover and
remove the cover with junction box. Save the screws and cover.
Clean the countertop.
Apply a continuous bead of quality sealant to the underside of
the sink rim.
Carefully position the sink in the countertop opening.
Turn the sink so the flat surface of the drain assembly is to the
front.
Assemble a clip and wing nut to each of the threaded studs.
NOTE: The wing nuts are designed to be tightened by hand. Do not
use a wrench. Tighten the wing nuts in rotation evenly, a little at a
time.
Carefully finger tighten each wing nut until no gap exists
between the sink rim and the countertop.
Immediately wipe away any excess sealant.
1032055-2-B
Control Box
Cover
Sealant
Stud
Screws
Sink
8
Drain
Assembly
Kohler Co.