Publicidad
Idiomas disponibles
Idiomas disponibles
5.2 Replacing the power supply
unit
▶
If you replace the power supply unit,
only use the original power supply unit
from the manufacturer (article number
0020292010 or 0020292011).
6 Decommissioning
1.
Deactivate the product in the myVAIL-
LANT app.
2.
Reset the product to its factory set-
tings by pressing and holding the but-
ton next to the LED for at least 10
seconds.
◁
The LED goes out as soon as the
resetting process starts.
◁
Your information and settings are
deleted.
◁
The connection to the coupled ra-
dio room thermostat is deleted.
3.
Decommission the product.
7 Customer service
The contact details for our customer ser-
vice are provided on the back page, in the
appendix or on our website.
No software is perfect and, for that reason,
we are always working on additional im-
provements for you. If you find indications
of a weak spot or of a safety issue, please
notify us by sending a message to:
secure@myvaillant.com
8 Product data
in accordance with EU
Ordinance no. 811/2013,
812/2013
Depending on the system configuration,
this product can work as a weather-com-
pensated control with room temperature
modulation and therefore contains the cor-
rection factor for control technology class
8000023372_00 Installation instructions
VI. A deviation from the seasonal room-
heating efficiency is possible depending on
the system configuration.
Temperature control class
Contribution to the seasonal
room-heating energy effi-
ciency ɳs
9 Technical data
Technical data – Wi-Fi gateway
Rated voltage
Requirement for the
power supply *
Average power con-
sumption
WLAN radio frequency
band
WLAN radio frequency
output (max. e.r.p.)
WLAN channels
WLAN encryption
IP assignment
Maximum environ-
mental temperature
Extra low-voltage wire
(bus line) – cross-sec-
tion
Height
Width
Depth
IP rating
Protection class
Permitted degree of
environmental pollution
* Applies for use with the connection cable
for the direct connection to the heat gener-
ator.
Technical data – Plug-in power sup-
ply unit
Rated voltage
Rated current
Output AC voltage
VI
4.0 %
5 to 24 V
ES1 or PS1 in
accordance with
IEC 62368-1
3 W
2.4 GHz
17.5 dBm
1 – 13
WPA2-PSK,
WPA3 personal
DHCP
50 ℃
≥ 0.75 mm²
96 mm
122 mm
36 mm
IP 21
III
2
120 to 230 V
AC
0.3 A
5 V
17
Publicidad
