CASO DESIGN M 20 Cube Ceramic Manual De Instrucciones página 55

14.2 Cleaning
 Cooking chamber and inside of door
► Always remove grease residues in the device, as these residues can otherwise
ignite.

Keep the cooking chamber of the device clean. Wipe off any spattered or spilt food from
the walls of the cooking chamber with a damp cloth.
If the device is excessively dirty, you can use a mild cleaning agent.

Wipe the door, window and the door gaskets with a damp cloth, to remove any spatters
and spilt food. Residues on the door gasket can mean that the door does not close
properly any more, which will cause the microwaves to escape.

Wipe off any steam, which has settled on the device door, with a soft cloth. This may be
the case if the device is used in an extremely damp environment and is normal.

Smells can be removed from the device by mixing a cup of water with the juice and the
skin of a lemon, pouring this into a deep microwave-proof bowl and allowing it to cook
in Microwave mode for five minutes. Then, dry off the device thoroughly with a soft
cloth.

After cleaning the interior space, leave the device door open until the interior of the
device is completely dry.
 Front of device and operating panel

Clean the front of the device and the operating panel with a soft, slightly damp cloth.

Please bear in mind that the operating panel does not get wet. Use a soft, damp cloth
for cleaning.
► Leave the device door open to prevent the device from being re-started accidentally.
 Exterior housing

Clean the exterior surfaces of the device with a damp cloth.

Wipe the bottom of the device with a mild cleaning agent. If the floor of the device is
excessively dirty, you can also use a mild cleaning agent.
15 Troubleshooting
This chapter provides you with important notices with regard to operating the device.
Observe the following notices to avoid dangers and damages:
Danger of fire
Please note
base plate
55