Publicidad
Idiomas disponibles
Idiomas disponibles
ENGLISH
Explanation
of
general view
@
Battery holder
0
Light angle
@
Front hook
@
Battery cartridge
(vertically adjustable)
@
Tighten (clockwise)
@
Push button
@
Head band
@
Loosen (counterclockwise)
0
Screw
8
Band clips
@
Bulb
0
Set plate
@
Front band clip
@
Spare bulb
8
Switch
0
Belt hook
SPECIFICATIONS
Model
ML121
Bulb
.....................................................
12.5
V
0.29
A
Dimensions
Head light
......................
80 mm x
50
mm x 80 mm
Battery holder
............
94
mm x
100
m m
x 102
mm
Net weight
..................................................
0.26
kg
Due to the continuing program of research and
development, the specifications herein are subject
9. Do not disassemble the charger or battery
cartridge; take it to a qualified serviceman
when service or repair is required. Incorrect
reassembly may result in a risk of electric
shock or fire.
10.
If any problem develops, consult your nearest
Makita Service Center or dealer. To maintain
product safety and reliability, repairs, mainte-
nance or adjustment should be carried out by
a Makita Authorized Service Center.
to change without prior notice.
Note: Specifications may differ from country to
SAVE THESE INSTRUCTIONS.
country.
OPERATING INSTRUCTIONS
Always remove the battery cartridge from the bat-
Do
not place the head light face down on a surface
For batterv cartridqes with push buttons
IMPORTANT SAFETY INSTRUCTIONS
CAUTION:
WARNING:
When using electric tools, basic safety precautions
should always be followed to reduce the risk of fire,
electric shock, and personal injury, including the fol-
lowing:
tery holder when not using the utility light.
with the light on.
READ ALL INSTRUCTIONS.
1.
2.
3.
4.
5.
6.
7.
8.
Read this instruction manual and the charger
instruction manual carefully before use.
This utility light is not waterproof. Do not use
it in damp or wet locations. Do not expose it to
rain or snow. Do not wash it in water.
A short circuit can cause a large current flow,
overheating, possible burns and even a break-
down.
(1) Do not touch the inside of the head light
with tweezers, metal tools, etc.
(2) Do not touch the battery terminals with any
conductive material.
(3) Avoid storing the battery cartridge in a
container with any metal objects such as
nails, coins, etc.
Never expose the battery cartridge to flames,
fire or great heat. Breakage may cause release
of injurious material.
Do
not shine light continuously into some-
one's eyes. Their vision may
be
damaged.
Do not place the head light face down on a
surface with the light on.
It
may cause a fire.
Do not abuse cord. Never carry head light
and/or battery holder by the cord. Keep cord
from heat, oil and sharp edges. Be careful so
that the cord will not be stepped on
or
caught
by something.
Inspect cords periodically and, if damaged,
have repaired by authorized service facility.
-
(Fig. 1)
Charae the battew cartridqe with the Makita charger
befo;
use. After c'harging,insert the battery cartridge
into the battery holder all the way until
it
locks in place
with a little click.
For battery cartridges without push buttons
-
(Fig. 2)
When usinq the battery cartridges without push but-
tons, first install the set plate on the battery holder
with the screw provided as shown in Fig. 2. Then
insert the battery cartridge into the battery holder and
snap the set plate back into place.
Switch action (Fig.
3)
Turn the switch knob clockwise or counterclockwise.
The light will be alternately turned on and
off
with a
1/4
turn.
Wearing head light (Fig. 4)
Wear the head light on your head using the head
band to secure it in place. You can carry the battery
holder on your waist belt using the
belt
hook. If the
head band is too loose or too tight, adjust its length
with the band clips.
The light angle can be adjusted up and down.
Slip the cord between the protrusions of the band clip
as shown in Fig.
4
to keep it out of the way.
NOTE:
This utility light can be used as a stationary type light
as well. Install the head light on the battery holder
using the front hook on the battery holder as shown in
Fig. 5.
5
Publicidad
