Publicidad
Idiomas disponibles
Idiomas disponibles
Installation
Instructions
TEST FOR LEAKS
-AWARNING - Neveruseon
open florae to test for gas leaks.
Check all connections
for leaks with soapy solution
or equivalent.
Applg a soap solution. The leak test solution must
not contain ammonia,
which could cause damage
to the brass fittings.
If leaks are found, close the valve, retighten
the joint
and repeat the soap test.
OpenGas
ELECTRICAL CONNECTION
INFORMATION
FOR GAS DRYERS
-A WARNING - To reduce the risk of
fire, electricol
shock ond personal
injurg:
• Do not use an extension
cord or an adapter
plug
with this appliance.
• The drger must be electricallg
grounded
in
accordance
with local codes and ordinances,
or in the absence of local codes, in accordance
with the NATIONAL ELECTRICAL CODE, ANSI/NFPA
NO. 70.
ELECTRICAL REQUIREMENTS
FOR GAS DRYERS
This appliance
must be supplied with J_20V,60Hz,
and connected
to a properlg grounded
branch
circuit, protected
bg a 15- or 20-amp
circuit
breaker or time-delag
fuse.
If electrical supplg provided
does not meet
the above specifications,
it is recommended
that
a licensed electrician
install an approved
outlet.
A WARNING
-
This dryer is equipped
with a three-prong
{grounding)
plug for your
protection
against shock hazard and should be
plugged directl U into a properlg grounded
three-
prong receptacle.
Do not cut or remove the
grounding
terminal from this plug.
f
I II II
Ensure p roper
• "
"
ground exists
beforeuse.
If local codes permit, an external ground wire (not
provided), which meets local codes, mag be added
bg attaching
to the green ground screw on the rear
of the drger, and to an alternate
established
ground.
Ensure proper ground
exists before use.
Ground
Screw
19
Publicidad
